www.ti.com

CDCE706

SCAS815A – OCTOBER 2005 – REVISED OCTOBER 2005

To achieve an independent output frequency the reference divider M and the feedback divider N for each PLL

can be set to values from 1 up to 511 for the M-Divider and from 1 up to 4095 for the N-Divider. The PLL-VCO

(voltage controlled oscillator) frequency than is routed to the free programmable output switching matrix to any of

the six outputs. The switching matrix includes an additional 7-bit post-divider (1-to-127) and an inverting logic for

each output. The individual selectable inverting logic allows two LVCMOS outputs to work as pseudo differential

signal (0 degrees and 180 degree phase shift).

The deep M/N divider ratio allows the generation of zero ppm clocks from e.g., a 27-MHz reference input

frequency.

The CDCE706 includes three PLLs of those one supports SSC (spread-spectrum clocking). PLL1, PLL2, and

PLL3 are designed for frequencies up to 300 MHz and optimized for zero-ppm applications with wide divider

factors.

PLL2 also supports center-spread and down-spread spectrum clocking (SSC) which effectively lower the energy

for the selected frequency range. The electro-magnetic interference (EMI) will be significantly reduced. Also, the

slew-rate controllable (SRC) output edges minimize EMI noise.

Based on the PLL frequency and the divider settings, the internal loop filter components will be automatically

adjusted to achieve high stability and optimized jitter transfer characteristic of the PLL.

The device supports non-volatile EEPROM programming for ease-customized application. It is pre-programmed

with a factory default configuration (see Figure 8) and can be re-programmed to a different application

configuration before it goes onto the PCB or re-programmed by in-system programming. A different register

setting is programmed via the serial SMBus Interface.

Two free programmable inputs, S0 and S1, can be used to control for each application the most demanding logic

control settings (outputs disable to low, outputs 3-state, power down, PLL bypass, etc).

The CDCE706 has three power supply pins, V

operates from a single 3.3-V supply voltage. V

V

supplies can be 2.3 V to 3.6 V.

The CDCE706 is characterized for operation from –40

°C to 85°C.

2