FUSB380

www.onsemi.com

3

Table 3. MAXIMUM RATINGS

Symbol

Parameter

Conditions

Min

Typ

Max

Units

CC and VCONNx pins (Note 1)

−0.5

28

V

Maximum Junction Temperature

+150

°C

−65

+150

°C

Lead Temperature (Soldering 10 Seconds) (Note 2)

+260

°C

ESD

Human Body Model, JEDEDC JESD22−A114

Connector Pins (CC, VCONNx)

4.5

kV

Others

2

Charged Device Model, JEDEC LESD22−C101

All Pins

2

Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality

should not be assumed, damage may occur and reliability may be affected.

1. Refer to ELECTRICAL CHARACTERISTICS, RECOMMENDED OPERATING RANGES and/or APPLICATION INFORMATION for Safe

Operating parameters.

2. For information, please refer to our Soldering and Mounting Techniques Reference Manual, SOLDERRM/D

Table 4. RECOMMENDED OPERATING RANGES

Symbol

Parameter

Conditions

Min

Typ

Max

Units

VCONN Voltage (Note 3)

2.4

5.5

V

Operating Ambient Temperature

−40

+85

°C

Functional operation above the stresses listed in the Recommended Operating Ranges is not implied. Extended exposure to stresses beyond

the Recommended Operating Ranges limits may affect device reliability.

3. Programming Voltage range = 4.7 V to 5.5 V

Symbol

Parameter

Conditions

Min

Typ

Max

Units

Current Consumption

BMC PD standby current

VCONN = 2.4 to 5.5 Device

attached, BMC PD active but not

sending or receiving, Ra weakened.

Other VCONN pin floating. CC

pulled−up/down/float.

400

mA

BASEBAND PD SYSTEM

UI

Unit Interval

3.03

3.33

3.7

ms

TRANSMITTER

Maximum difference between the bit−rate

during the payload and last 32 bits of pre-

amble

0.25

%

Time to cease driving the line after the end

of the last bit of the Frame

23

ms

Time to cease driving the line after the final

high−to−low transition

1

ms

Time before the start of the first bit of the

preamble when the transmitter shall start

driving the line

−1

1

ms

Any PD transmission cannot be sent out be-

from receiving or sending a packet

25

ms

GoodCRC response time from last transition

following EOP to start of preamble of Good-

CRC

25

195

ms

Rise Time

300

ns

Fall Time

300

ns