AT25PE20 datasheet(46/64 Pages) DIALOG

46 / 64 page

AT25PE20

DS-25PE20–139C–8/2018

21.

Utilizing the RapidS Function

To take advantage of the RapidS function’s ability to operate at higher clock frequencies, a full clock cycle must be used

to transmit data back and forth across the serial bus. The DataFlash-L is designed to always clock its data out on the

falling edge of the SCK signal and clock data in on the rising edge of SCK.

For full clock cycle operation to be achieved, when the DataFlash-L is clocking data out on the falling edge of SCK, the

host controller should wait until the next falling edge of SCK to latch the data in. Similarly, the host controller should clock

its data out on the rising edge of SCK in order to give the DataFlash-L a full clock cycle to latch the incoming data in on

the next rising edge of SCK.

Figure 21-1. RapidS Mode

SCK

MOSI

MISO

MOSI = Master Out, Slave In

MISO = Master In, Slave Out

The Master is the host controller and the Slave is the DataFlash.

The Master always clocks data out on the rising edge of SCK and always clocks data in on the falling edge of SCK.

The Slave always clocks data out on the falling edge of SCK and always clocks data in on the rising edge of SCK.

Master clocks out first bit of BYTE-MOSI on the rising edge of SCK

Slave clocks in first bit of BYTE-MOSI on the next rising edge of SCK

Master clocks out second bit of BYTE-MOSI on the same rising edge of SCK

Last bit of BYTE-MOSI is clocked out from the Master

Last bit of BYTE-MOSI is clocked into the slave

Slave clocks out first bit of BYTE-SO

Master clocks in first bit of BYTE-SO

Slave clocks out second bit of BYTE-SO

Master clocks in last bit of BYTE-SO

BYTE-MOSI

MSB

LSB

BYTE-SO

MSB

LSB

Slave

AT25PE20 Datasheet(PDF) 46 Page - Dialog Semiconductor