LM74700

GATE

CATHODE

EN

ANODE

VCAP

GND

TVS+

SMBJ58A

Voltage

Regulator

22 nF

VCAP

0.1 µF

Q1

47 µF

TVS-

SMBJ26A

Figure 9-3. Typical 24-V Battery Protection With Two Uni-directional TVS

The breakdown voltage of the TVS+ must be higher than 48-V jump start voltage, less than the absolute

maximum ratings of anode and enable pin of LM74700-EP (65 V) and must withstand 65-V suppressed load

dump. The breakdown voltage of TVS– must be lower than maximum reverse battery voltage –32 V, so that the

TVS– is not damaged due to long time exposure to reverse connected battery.

During ISO 7637-2 pulse 1, the input voltage goes up to –600 V with a generator impedance of 50 Ω. This action

translates to 12 A flowing through the TVS–. The clamping voltage of the TVS- cannot be same as that of 12-V

battery protection circuit. Because during the ISO 7637-2 pulse, the Anode to Cathode voltage seen is equal to

(– TVS Clamping voltage + Output capacitor voltage). For 24-V battery application, the maximum battery voltage

is 32 V, then the clamping voltage of the TVS– must not exceed 75 V – 32 V = 43 V.

Single bi-directional TVS cannot be used for 24-V battery protection because breakdown voltage for TVS+

≥ 65 V, maximum clamping voltage is ≤ 43 V and the clamping voltage cannot be less than the breakdown

voltage. Two un-directional TVS connected back-to-back needs to be used at the input. For positive side TVS+,

SMBJ58A with the breakdown voltage of 64.4 V (minimum), 67.8 (typical) is recommended. For the negative

side TVS–, SMBJ26A with breakdown voltage close to 32-V (to withstand maximum reverse battery voltage –32

V) and maximum clamping voltage of 42.1 V is recommended.

For 24-V battery protection, a 75-V rated MOSFET is recommended to be used along with SMBJ26A and

SMBJ58A connected back-to-back at the input.

LM74700-EP

SNOSDD6 – SEPTEMBER 2021

www.ti.com

18

Submit Document Feedback

Copyright © 2021 Texas Instruments Incorporated

Product Folder Links: LM74700-EP