MCP7940NT-ESLASHMS datasheet(31/58 Pages) MICROCHIP

31 / 58 page

 2011-2022 Microchip Technology Inc. and its subsidiares

DS20005010J-page 31

MCP7940N

5.6.2

COARSE TRIM MODE

When CRSTRIM = 1, Coarse Trim mode is enabled.

While in this mode, the MCP7940N will apply trimming

at a rate of 128 Hz. If SQWEN is set, the MFP will out-

put a trimmed 64 Hz nominal clock signal.

Because trimming is applied at a rate of 128 Hz rather

than

once

every

minute,

each

step

the

TRIMVAL<6:0> value has a significantly larger effect

on the resulting time deviation and output clock

frequency.

By monitoring the MFP output frequency while in this

mode, the user can easily observe the TRIMVAL<6:0>

value affecting the clock timing.

TABLE 5-12:

SUMMARY OF REGISTERS ASSOCIATED WITH DIGITAL TRIMMING

Note 1: The 64 Hz Coarse Trim mode square

wave output is not available while operat-

ing from the backup power supply.

2: With Coarse Trim mode enabled, the

TRIMVAL<6:0> value has a drastic effect

on timing. Leaving the mode enabled

during normal operation will likely result

in inaccurate time.

Name

Bit 7

Bit 6

Bit 5

Bit 4

Bit 3

Bit 2

Bit 1

Bit 0

on Page

CONTROL

OUT

SQWEN

ALM1EN

ALM0EN

EXTOSC

CRSTRIM

SQWFS1

SQWFS0

OSCTRIM

SIGN

TRIMVAL6 TRIMVAL5 TRIMVAL4

TRIMVAL3

TRIMVAL2 TRIMVAL1 TRIMVAL0

Legend:

— = unimplemented location, read as ‘0’. Shaded cells are not used by digital trimming.

MCP7940NT-E/MS Datasheet(PDF) 31 Page - Microchip Technology

MCP7940NT-E/MS Datasheet(HTML) 31 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58

Datasheet Download

Link URL