AT49LL080 datasheet(5/31 Pages) ATMEL

5 / 31 page

AT49LL080

3273C–FLASH–5/03

Low Pin Count

Interface (LPC)

Table 2 lists the seven required signals used for the LPC interface.

LAD[3:0]: The LAD[3:0] signal lines communicate address, control, and data informa-

tion over the LPC bus between a master and a peripheral. The information

communicated are: start, stop (abort a cycle), transfer type (memory, I/O, DMA), trans-

fer direction (read/write), address, data, wait states, DMA channel, and bus master

grant.

LFRAME: LFRAME is used by the master to indicate the start of cycles and the termina-

tion of cycles due to an abort or time-out condition. This signal is to be used be by

peripherals to know when to monitor the bus for a cycle.

The LFRAME signal is used as a general notification that the LAD[3:0] lines contain

information relative to the start or stop of a cycle, and that peripherals must monitor the

bus to determine whether the cycle is intended for them. The benefit to peripherals of

LFRAME is, it allows them to enter lower power states internally.

When peripherals sample LFRAME active, they are to immediately stop driving the

LAD[3:0] signal lines on the next clock and monitor the bus for new cycle information.

RESET: RST or INIT at VIL initiates a device reset. In read mode, RST or INIT low

deselects the memory, places output drivers in a high-impedance state, and turns off all

GNDa

SUPPLY

ANALOG GROUND: Should be tied to same plane as GND.

RFU

RESERVED FOR FUTURE USE: These pins are reserved for future

generations of this product and should be connected accordingly. These pins

may be left disconnected or driven. If they are driven, the voltage levels should

meet V

IH and VIL requirements.

A/A Mux = I/O[7:4]

NO CONNECT: Pin may be driven or floated. If it is driven, the voltage levels

should meet VIH and VIL.

RY/BY

OUTPUT

READY/BUSY: Valid only in A/A Mux Mode. This output pin is a reflection of bit

7 in the status register. This pin is used to determine sector erase or program

completion.

Table 1. Pin Description (Continued)

Symbol

Type

Interface

Name and Function

LPC

A/A Mux

Table 2. LPC Required Signal List

Signal

Direction

Description

Peripheral

Master

LAD[3:0]

I/O

Multiplexed command, address and data

LFRAME

Indicates start of a new cycle, termination of broken

cycle.

RST

Reset: Same as PCI Reset on the master. The master

does not need this signal if it already has PCIRST on its

interface.

CLK

Clock: Same 33 MHz clock as PCI clock on the master.

Same clock phase with typical PCI skew. The master

does not need this signal if it already has PCICLK on its

interface.

AT49LL080 Datasheet(PDF) 5 Page - ATMEL Corporation

AT49LL080 Datasheet(HTML) 5 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31

Datasheet Download

Link URL