IDT80KSW0002

Datasheet

CPS-16 Datasheet

47

April 6, 2016

At recommended operating conditions with VDD3 = 2.5V ± 100mV

Table 13 IRQ Electrical Specifications (VDD3 = 2.5V ± 100mV)

Figure 13 IRQ Timing Diagram

The IRQ pin is an open-drain driver. IDT recommends a weak pull-up resistor (2-10k Ohm) be placed on this pin to VDD3. The IRQ pin goes active low

when any special error filter error flag is set, and is cleared when all error flags are reset. Please refer to the device user’s manual for full detail.

15 Serial RapidIO Ports

Overview

The CPS-16’s SERDES are in full compliance to the RapidIO AC specifications for the LP-Serial physical layer [5]. This section provides those

specifications for reference. The electrical specifications cover both single and multiple-lane links. Two transmitters (short run and long run) and a

single receiver are specified for each of three baud rates, 1.25, 2.50, and 3.125 GBaud.

Two transmitter specifications allow for solutions ranging from simple chip-to-chip interconnect to driving two connectors across a backplane. A single

receiver specification is given that will accept signals from both the short run and long run transmitter specifications.

The short run transmitter setting should be used mainly for chip-to-chip connections on either the same printed circuit board or across a single

connector. This covers the case where connections are made to a mezzanine (daughter) card. The minimum swings of the short run specification

reduce the overall power used by the transceivers.

The long run transmitter specifications use larger voltage swings that are capable of driving signals across backplanes. This allows a user to drive

signals across two connectors and a backplane. The CPS-16 can drive beyond the specification distance of at least 50 cm at all baud rates. Please

use IDT’s Simulation Kit IO models to determine reach and signal quality for a given PCB design.

Parameter

Symbol

Min

Max

Unit

Low level output voltage (IOL = 2mA, VDD3 =

Min.)

VOL

0

0.4

V

Output fall time from VIH(min) to VIL(max) with a

bus capacitance from 10pF to 400pF

tOF

-

25

ns

Input current each I/O pin (input voltage is

between 0.1 x VDD3 and 0.9 x VDD3 (max))

II

-10

10

uA

Capacitance for IRQ

CI

-

10

pF