X9260 datasheet(6/23 Pages) RENESAS

6 / 23 page

FN8170.3

August 29, 2006

Figure 1. Detailed Potentiometer Block Diagram

DEVICE DESCRIPTION

Wiper Counter Register (WCR)

The X9260 contains two Wiper Counter Registers, one

for each DCP potentiometer. The Wiper Counter

serial load counter with its outputs decoded to select

one of 256 switches along its resistor array. The

contents of the WCR can be altered in four ways: it

may be written directly by the host via the Write Wiper

Counter Register instruction (serial load); it may be

written indirectly by transferring the contents of one of

four associated data registers via the XFR Data

one step at a time by the Increment/Decrement

instruction (See Instruction section for more details).

Finally, it is loaded with the contents of its Data

The Wiper Counter Register is a volatile register; that

is, its contents are lost when the X9260 is powered-

down. Although the register is automatically loaded

with the value in DR0 upon power-up, this may be

different from the value present at power-down.

Power-up guidelines are recommended to ensure

proper loadings of the DR0 value into the WCR.

Data Registers (DR)

Each potentiometer has four 8-bit nonvolatile Data

Registers. These can be read or written directly by the

host. Data can also be transferred between any of the

four Data Registers and the associated Wiper Counter

Data Registers is a nonvolatile operation and will take

a maximum of 10ms.

If the application does not require storage of multiple

settings for the potentiometer, the Data Registers can

be used as regular memory locations for system

parameters or user preference data.

Bits [7:0] are used to store one of the 256 wiper

positions or data (0~255).

Status Register (SR)

This 1-bit Status Register is used to store the system

status.

WIP: Write In Progress status bit, read only.

– When WIP = 1, indicates that high-voltage write

cycle is in progress.

– When WIP = 0, indicates that no high-voltage write

cycle is in progress.

SERIAL DATA PATH

FROM INTERFACE

CIRCUITRY

SERIAL

BUS

INPUT

PARALLEL

BUS

INPUT

COUNTER

INC/DEC

LOGIC

UP/DN

CLK

MODIFIED SCK

UP/DN

IF WCR = 00[H] THEN RW = RL

IF WCR = FF[H] THEN RW = RH

WIPER

(WCR)

One of Two Potentiometers

(DR0)

(DR1)

(DR2)

(DR3)

X9260

X9260 Datasheet(PDF) 6 Page - Renesas Technology Corp

X9260 Datasheet(HTML) 6 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Datasheet Download

Link URL