PIC18F6310ESLASHPTSQTP datasheet(39/404 Pages) MICROCHIP

39 / 404 page

 2004 Microchip Technology Inc.

Preliminary

DS39635A-page 37

PIC18F6310/6410/8310/8410

2.8

Effects of Power Managed Modes

on the Various Clock Sources

When PRI_IDLE mode is selected, the designated

primary oscillator continues to run without interruption.

For all other power managed modes, the oscillator

using the OSC1 pin is disabled. The OSC1 pin (and

OSC2 pin, if used by the oscillator) will stop oscillating.

Secondary

Clock

modes

(SEC_RUN

and

SEC_IDLE), the Timer1 oscillator is operating and

providing the device clock. The Timer1 oscillator may

also run in all power managed modes if required to

clock Timer1 or Timer3.

In Internal Oscillator modes (RC_RUN and RC_IDLE),

the internal oscillator block provides the device clock

source. The 31 kHz INTRC output can be used directly

to provide the clock and may be enabled to support var-

ious special features, regardless of the power managed

mode (see Section 23.2 “Watchdog Timer (WDT)”

through Section 23.4 “Fail-Safe Clock Monitor” for

more information on WDT, Fail-Safe Clock Monitor and

Two-Speed Start-up). The INTOSC output at 8 MHz may

be used directly to clock the device, or may be divided

down by the postscaler. The INTOSC output is disabled

if the clock is provided directly from the INTRC output.

If the Sleep mode is selected, all clock sources are

stopped. Since all the transistor switching currents

have been stopped, Sleep mode achieves the lowest

current consumption of the device (only leakage

currents).

Enabling any on-chip feature that will operate during

Sleep will increase the current consumed during Sleep.

The INTRC is required to support WDT operation. The

Timer1 oscillator may be operating to support a

real-time clock. Other features may be operating that

do not require a device clock source (i.e., SSP slave,

PSP, INTn pins and others). Peripherals that may add

significant

current

consumption

are

listed

Section 26.2 “DC Characteristics: Power-Down and

Supply Current”.

2.9

Power-up Delays

Power-up delays are controlled by two timers, so that no

external Reset circuitry is required for most applications.

The delays ensure that the device is kept in Reset until

the device power supply is stable under normal

circumstances and the primary clock is operating and

stable. For additional information on power-up delays,

see Section 4.5 “Device Reset Timers”.

The first timer is the Power-up Timer (PWRT), which

provides a fixed delay on power-up (parameter 33,

Table 26-12). It is enabled by clearing (= 0) the

PWRTEN configuration bit.

The second timer is the Oscillator Start-up Timer

(OST), intended to keep the chip in Reset until the

crystal oscillator is stable (LP, XT and HS modes). The

OST does this by counting 1024 oscillator cycles

before allowing the oscillator to clock the device.

When the HSPLL Oscillator mode is selected, the

device is kept in Reset for an additional 2 ms, following

the HS mode OST delay, so the PLL can lock to the

incoming clock frequency.

There is a delay of interval TCSD (parameter 38,

Table 26-12)

following POR while the controller

becomes ready to execute instructions. This delay runs

concurrently with any other delays. This may be the

only delay that occurs when any of the EC, RC or INTIO

modes are used as the primary clock source.

TABLE 2-3:

OSC1 AND OSC2 PIN STATES IN SLEEP MODE

Oscillator Mode

OSC1 Pin

OSC2 Pin

RC, INTIO1

Floating, external resistor should pull high

At logic low (clock/4 output)

RCIO, INTIO2

Floating, external resistor should pull high

Configured as PORTA, bit 6

ECIO

Floating, pulled by external clock

Configured as PORTA, bit 6

Floating, pulled by external clock

At logic low (clock/4 output)

LP, XT and HS

Feedback inverter disabled at quiescent

voltage level

Feedback inverter disabled at quiescent

voltage level

Note:

See Table 4-2 in Section 4.0 “Reset” for time-outs due to Sleep and MCLR Reset.

PIC18F6310E/PTSQTP Datasheet(PDF) 39 Page - Microchip Technology

PIC18F6310E/PTSQTP Datasheet(HTML) 39 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL