M45PE80 datasheet(25/47 Pages) STMICROELECTRONICS

25 / 47 page

M45PE80

Instructions

25/47

6.8

Page Program (PP)

The Page Program (PP) instruction allows bytes to be programmed in the memory

(changing bits from 1 to 0, only). Before it can be accepted, a Write Enable (WREN)

instruction must previously have been executed. After the Write Enable (WREN) instruction

has been decoded, the device sets the Write Enable Latch (WEL).

The Page Program (PP) instruction is entered by driving Chip Select (S) Low, followed by

the instruction code, three address bytes and at least one data byte on Serial Data Input (D).

If the 8 least significant address bits (A7-A0) are not all zero, all transmitted data exceeding

the addressed page boundary roll over, and are programmed from the start address of the

same page (the one whose 8 least significant address bits (A7-A0) are all zero). Chip Select

(S) must be driven Low for the entire duration of the sequence.

The instruction sequence is shown in Figure 13.

If more than 256 bytes are sent to the device, previously latched data are discarded and the

last 256 data bytes are guaranteed to be programmed correctly within the same page. If less

than 256 Data bytes are sent to device, they are correctly programmed at the requested

addresses without having any effects on the other bytes of the same page.

For optimized timings, it is recommended to use the Page Program (PP) instruction to

program all consecutive targeted bytes in a single sequence versus using several Page

Program (PP) sequences with each containing only a few bytes (see Table 14: AC

characteristics (50 MHz operation)).

Chip Select (S) must be driven High after the eighth bit of the last data byte has been

latched in, otherwise the Page Program (PP) instruction is not executed.

As soon as Chip Select (S) is driven High, the self-timed Page Program cycle (whose

duration is tPP) is initiated. While the Page Program cycle is in progress, the Status Register

may be read to check the value of the Write In Progress (WIP) bit. The Write In Progress

(WIP) bit is 1 during the self-timed Page Program cycle, and is 0 when it is completed. At

some unspecified time before the cycle is complete, the Write Enable Latch (WEL) bit is

reset.

A Page Program (PP) instruction applied to a page that is Hardware Protected is not

executed.

Any Page Program (PP) instruction, while an Erase, Program or Write cycle is in progress, is

rejected without having any effects on the cycle that is in progress.

M45PE80 Datasheet(PDF) 25 Page - STMicroelectronics