www.ti.com

DISABLED STATES FOR THE PCM4222 AUDIO INTERFACES

PCM OUTPUT AND SAMPLING MODES

AUDIO SERIAL PORT INTERFACE

PCM4222

SBAS399A – OCTOBER 2006 – REVISED MARCH 2007

When a particular mode is disabled, the output data and clocks associated with that mode are driven low. The

exception is when MODEN is driven low, disabling the multi-bit modulator output. For this case, the data and

clock outputs associated with the modulator output are re-mapped to functions utilized for either PCM or DSD

mode operation.

The PCM4222 supports 24-bit linear PCM output data when the PCMEN input (pin 16) is forced high. The PCM

output is disabled when PCMEN is forced low. The 24-bit output data may be dithered to 20-, 18-, or 16-bits

using internal word length reduction circuitry. Refer to the Output Word Length Reduction section of this data

sheet for additional information.

The PCM4222 supports three PCM sampling modes, referred to as Normal, Double Speed, and Quad Speed.

The sampling mode is determined by the state of the FS0 and FS1 inputs (pins 19 and 20, respectively). Table 2

summarizes the sampling modes available for the PCM4222.

Normal sampling mode supports output sampling rates from 8kHz to 54kHz. The

∆Σ modulator operates with

128x oversampling in this mode. Both the Classic and Low Group Delay decimation filter responses are

available in Normal mode. The master clock (MCKI) rate must be 256x the desired output sampling rate for

Normal operation.

The Double Speed sampling mode supports output sampling rates from 54kHz to 108kHz. The delta-sigma

modulator operates with 64x oversampling in this mode. Both the Classic and Low Group Delay decimation filter

responses are available in Double Speed mode. The master clock (MCKI) rate must be 128x the desired output

sampling rate for Double Speed operation.

Quad Speed sampling mode supports output sampling rates from 108kHz to 216kHz. The delta-sigma modulator

operates with 32x oversampling in this mode. Only the Low Group Delay decimation filter response is available

in Quad Speed mode. The master clock (MCKI) rate must be 64x the desired output sampling rate for Quad

Speed operation.

Table 2. PCM Sampling Mode Configuration

FS1 (pin 20)

FS0 (pin 19)

SAMPLING MODE

LO

LO

Normal, 8kHz

≤ f

LO

HI

HI

LO

HI

HI

Reserved

The PCM output mode supports a three-wire synchronous serial interface. This interface includes a serial data

output (DATA, pin 32), a serial bit or data clock (BCK, pin 33), and a left/right word clock (LRCK, pin 34). The

BCK and LRCK clock pins may be inputs or outputs, dependent upon the Slave or Master mode configuration.

Figure 41 illustrates Slave and Master mode serial port connections to an external audio signal processor or

host device.

The audio serial port supports four data formats that are illustrated in Figure 42, Figure 44, and Figure 45. The

to eight channels of audio output data on a single data line. The audio data format is selected using the FMT0

and FMT1 inputs (pins 44 and 43, respectively). Table 3 summarizes the audio data format options. For all

formats, audio data are represented as two’s complement binary data, with the MSB transmitted first.

Regardless of the format selection, audio data are always clocked out of the port on the falling edge of the BCK

clock.

20

Submit Documentation Feedback