DSPIC24H datasheet(2/80 Pages) MICROCHIP

2 / 80 page

dsPIC33F/PIC24H PROGRAMMING SPECIFICATION

DS70152D-page 2

Preliminary

FIGURE 2-1:

PROGRAMMING SYSTEM

OVERVIEW FOR

ENHANCED ICSP™

This specification is divided into major sections that

describe the programming methods independently.

Section 3.0 “Device Programming – Enhanced

ICSP”

describes

the

Enhanced

ICSP

method.

Section 5.0 “Device Programming – ICSP” describes

the ICSP method.

2.1

Power Requirements

All devices in the dsPIC33F/PIC24H family are dual volt-

age supply designs: one supply for the core and another

for the peripherals and I/O pins. A regulator is provided

on-chip to alleviate the need for two external voltage

supplies.

All of the dsPIC33F/PIC24H devices power their core

digital logic at a nominal 2.5V. To simplify system

design, all devices in the dsPIC33F/PIC24H Program-

ming Specification family incorporate an on-chip regu-

lator that allows the device to run its core logic from

VDD.

The regulator provides power to the core from the other

VDD pins. A low-ESR capacitor (such as tantalum) must

be connected to the VDDCORE pin (Figure 2-2). This

helps to maintain the stability of the regulator. The

specifications for core voltage and capacitance are

listed in Section TABLE 8-1: “AC/DC Characteristics

and Timing Requirements”.

FIGURE 2-2:

CONNECTIONS FOR THE

ON-CHIP REGULATOR

2.2

Program Memory Write/Erase

Requirements

The program Flash memory on the dsPIC33F/PIC24H

has a specific write/erase requirement that must be

adhered to for proper device operation. The rule is that

any given word in memory must not be written without

first erasing the page in which it is located. Thus, the

easiest way to conform to this rule is to write all the data

in a programming block within one write cycle. The pro-

gramming methods specified in this document comply

with this requirement.

dsPIC33F/PIC24H

Programmer

Programming

Executive

On-Chip Memory

Note:

A program memory word can be pro-

grammed twice before an erase, but only

if (a) the same data is used in both pro-

gram operations or (b) bits containing ‘1’

are set to ‘0’ but no ‘0’ is set to ‘1’.

Note

These are typical operating voltages. Refer

to Section TABLE 8-1: “AC/DC Charac-

teristics and Timing Requirements” for

the full operating ranges of VDD and

VDD

VDDCORE

VSS

dsPIC33F/PIC24H

3.3V

DSPIC24H Datasheet(PDF) 2 Page - Microchip Technology

DSPIC24H Datasheet(HTML) 2 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80

Datasheet Download

Link URL