The Embedded I/O Company

TPMC310

Conduction Cooled PMC , Isolated 2 x CAN Bus

Application Information

The TPMC310 is a conduction cooled single-width 32 bit

PMC module providing two channel of high speed CAN

bus interface.

The PLX PCI9030 PCI Target Chip is used for the PCI

interface.

Two Philips SJA1000 CAN controllers (CAN specification

2.0B supported) are used for the two CAN bus channels.

The CAN bus I/O interface provides two independent

channels, isolated from system logic and from each other.

CAN High Speed transceivers are used for the CAN bus

I/O interface. An on board termination option (solder pads)

is provided for each CAN bus channel allowing to

configure on board termination and pass through mode for

the CAN bus.

The TPMC310 uses the P14 I/O connector for the CAN

bus I/O interface.

Software support (TDRV010-SW-xx) for different operating

systems is available.

Technical Information

 Conduction Cooled single-width 32 bit PMC module

conforming to IEEE P1386.1

 PCI 2.1 compliant interface

 3.3V and 5V PCI Signaling Voltage

 Board size: 144 mm x 74 mm

 CAN Bus Interface

• Two channel High Speed CAN interface

• Two Philips SJA1000 CAN controller

• Supports CAN specification 2.0B

• I/O interface based on TJA1050 transceiver,

channels isolated from system logic and from each

other

• On board termination option for each CAN bus

channel

 Operating temperature range –40°C to +85°C

TEWS TECHNOLOGIES GmbH keeps the right to change technical specification without further notice.

All trademarks mentioned are property of their respective owners.

Issue 1.1.1

2017-08-31

TEWS TECHNOLOGIES GmbH

Am Bahnhof 7

25469 Halstenbek, Germany

Phone: +49 (0) 4101 4058 0

Fax: +49 (0) 4101 4058 19

e-mail: info@tews.com

www.tews.com