V

Parameter

Conditions

LM2902

Units

Min

Typ

Max

Short Circuit to Ground

(Note 5) V

40

60

mA

Input Offset Voltage

(Note 9)

10

mV

V

R

Ω

7

µV/˚C

Input Offset Current

I

45

200

nA

I

R

Ω

10

pA/˚C

Input Bias Current

I

40

500

nA

Input Common-Mode

Voltage Range (Note 11)

V

0V

V

Large Signal Voltage Gain

V

R

L

≥ 2kΩ

15

V/mV

Output

Voltage

V

OH

V

R

Ω

23

24

V

Swing

V

OL

V

Ω

5

100

mV

Output

Current

Source

V

V

IN

10

20

V

IN

V

mA

Sink

V

IN

5

8

V

IN

V

Note 4: For operating at high temperatures, the LM2902EP must be derated based on a +125˚C maximum junction temperature and a thermal resistance of 88˚C/W

which applies for the device soldered in a printed circuit board, operating in a still air ambient. The dissipation is the total of all four amplifiers — use external resistors,

where possible, to allow the amplifier to saturate of to reduce the power which is dissipated in the integrated circuit.

dissipation ratings and cause eventual destruction. Destructive dissipation can result from simultaneous shorts on all amplifiers.

Note 6: This input current will only exist when the voltage at any of the input leads is driven negative. It is due to the collector-base junction of the input PNP

transistors becoming forward biased and thereby acting as input diode clamps. In addition to this diode action, there is also lateral NPN parasitic transistor action

that an input is driven negative. This is not destructive and normal output states will re-establish when the input voltage, which was negative, again returns to a value

greater than −0.3V (at 25˚C).

Note 7: The LM2902EP specifications are limited to −40˚C

Note 8: "Testing and other quality control techniques are used to the extent deemed necessary to ensure product performance over the specified temperature

range. Product may not necessarily be tested across the full temperature range and all parameters may not necessarily be tested. In the absence of specific

PARAMETRIC testing, product performance is assured by characterization and/or design."

Note 10: The direction of the input current is out of the IC due to the PNP input stage. This current is essentially constant, independent of the state of the output

so no loading change exists on the input lines.

Note 11: The input common-mode voltage of either input signal voltage should not be allowed to go negative by more than 0.3V (at 25˚C). The upper end of the

Note 12: Due to proximity of external components, insure that coupling is not originating via stray capacitance between these external parts. This typically can be

detected as this type of capacitance increases at higher frequencies.

Note 13: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur.

Note 14: Human body model, 1.5 k

Ω in series with 100 pF.

Note 15: The LM124 within this data sheet’s graphics is referenced because of it’s a similarity to the LM2902, however is not offered in this data sheet.

www.national.com

4