• Changed parameter name to Gain drift and added test condition "TA = –40°C to +85°C" for gain drift in

Electrical Characteristics for clarity.....................................................................................................................6

• Changed parameter names from "Voltage - Positive" to "Positive output voltage swing" and from "Voltage -

Negative" to "Negative output voltage swing" in Electrical Characteristics ........................................................6

• Deleted typical positive and negative output voltage swing specifications in Electrical Characteristics ............6

• Added test condition "Continuous to VS / 2" short-circuit current specification in Electrical Characteristics

for clarity............................................................................................................................................................. 6

• Changed typical bandwidth specification for G = 10 from 700 kHz to 600 kHz in Electrical Characteristics ..... 6

• Changed typical slew rate specification from 4 V/µs to 1.2 V/µs in Electrical Characteristics ...........................6

• Changed typical settling time specification for G = 1, G = 10, from 7 µs to 9 µs in Electrical Characteristics .....

............................................................................................................................................................................6

• Deleted parameter "Temperature Range" as made redundant by "Recommended Operating Conditions" and

"Absolute Maximum Ratings" ............................................................................................................................ 6

• Changed parameter name to "Total quiescent current" and deleted redundant voltage range, operating

temperature range, and specification temperature range specifications from Electrical Characteristics ...........6

• Added test conditions below the Typical Characteristics title..............................................................................8

• Changed Figure 6-1, Gain vs Frequency ...........................................................................................................8

• Changed Figure 6-3, Positive Power Supply Rejection vs Frequency .............................................................. 8

• Changed Figure 6-4, Negative Power Supply Rejection vs Frequency .............................................................8

• Changed Figure 6-7, Crosstalk vs Frequency ................................................................................................... 8

• Changed Figure 6-8, Input-Referred Voltage Noise vs Frequency ....................................................................8

• Changed Figure 6-9, Settling Time vs Gain .......................................................................................................8

• Changed Figure 6-11, Input Overvoltage V/I Characteristics .............................................................................8

• Changed Figure 6-12, Offset Voltage Warm-Up ................................................................................................8

• Changed Output Voltage Swing vs Output Current, into two separate plots, one for positive (Figure 6-14) and

one for negative (Figure 6-15)............................................................................................................................ 8

• Changed Figure 6-22 to Figure 6-24, Large-Signal Step Response ................................................................. 8

www.ti.com

INA2128

SBOS035B – DECEMBER 1995 – REVISED MAY 2023

Copyright © 2023 Texas Instruments Incorporated

Submit Document Feedback

3

Product Folder Links: INA2128