ST62T30B datasheet(51/86 Pages) STMICROELECTRONICS

51 / 86 page

51/86

ST62T30B ST62E30B

TIMINGS MEASUREMENT MODES(Cont’d)

CP2 triggered restart mode with CP2 event de-

tection.

This mode is enabled for RLDSEL2=1

and

RLDSEL1=0.

As long as RUNRES bit is set, an external event

on CP2 pin generates both, at first the capture into

CP, and then the reload from RLCP. Capture into

CP on CP2 event is enabled only if CP2FLG and

CP2ERR are cleared, otherwise only reload func-

tions from RLCP are performed.

An external event on CP1 activates CP1FLG or

CP1ERR flags without any impact on the reload or

capture functions.

Note: After Reset, the first CP2 event will capture

the 0000h state of the counter into CP and then

will restart the counter after loading it from RLCP.

CP2FLG flag must always be cleared to execute

another capture into CP.

Software triggered restart mode with CP2

event detection.

This mode is enabled for RLDSEL2=0

and

RLDSEL1=0.

RUNRES bit setting initiates the reload and startup

of the downcounting, while CP2 is used as strobe

source for the CT capture into CP register.

Figure 30. CP2 Triggered Restart Mode with CP2 Event Detection

Figure 31. Software Triggered Restart Mode with CP2 Event Detection

VR02007C

CP1

No action

Set CP2ERR

First Capture CT into CP

CP2

Set CP1ERR

Set CP1FLG

Reload CT from RLCP

Then Reload CT from RLCP

Set CP2FLG

Reload CT from RLCP

VR02007D

COUNTER

CP1

CP1 disabled

0000h

Load Counter from RLCP and Startup

RUNRES

Software Reset

Set CP1FLG

CP2 disabled

CP2

Set CP2ERR

CP1 disabled

Set CP1ERR

Capture CT into CP

Set CP2FLG

ST62T30B Datasheet(PDF) 51 Page - STMicroelectronics

ST62T30B Datasheet(HTML) 51 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86

Datasheet Download

Link URL