HD6432351 datasheet(354/1025 Pages) RENESAS

354 / 1025 page

Section 8 Data Transfer Controller (DTC)

Rev. 3.00 Sep 15, 2006 page 320 of 988

REJ09B0330-0300

[2] Set the start address of the register information at the DTC vector address (H'04C0).

[3] Check that the SWDTE bit in DTVECR is 0. Check that there is currently no transfer activated

by software.

[4] Write 1 to the SWDTE bit and the vector number (H'60) to DTVECR. The write data is H'E0.

[5] Read DTVECR again and check that it is set to the vector number (H'60). If it is not, this

indicates that the write failed. This is presumably because an interrupt occurred between steps

3 and 4 and led to a different software activation. To activate this transfer, go back to step 3.

[6] If the write was successful, the DTC is activated and a block of 128 bytes of data is transferred.

[7] After the transfer, an SWDTEND interrupt occurs. The interrupt handling routine should clear

the SWDTE bit to 0 and perform other wrap-up processing.

8.4

Interrupts

An interrupt request is issued to the CPU when the DTC finishes the specified number of data

transfers, or a data transfer for which the DISEL bit was set to 1. In the case of interrupt activation,

the interrupt set as the activation source is generated. These interrupts to the CPU are subject to

CPU mask level and interrupt controller priority level control.

In the case of activation by software, a software activated data transfer end interrupt (SWDTEND)

is generated.

When the DISEL bit is 1 and one data transfer has ended, or the specified number of transfers

have ended, after data transfer ends, the SWDTE bit is held at 1 and an SWDTEND interrupt is

generated. The interrupt handling routine should clear the SWDTE bit to 0.

When the DTC is activated by software, an SWDTEND interrupt is not generated during a data

transfer wait or during data transfer even if the SWDTE bit is set to 1.

HD6432351 Datasheet(PDF) 354 Page - Renesas Technology Corp