| Electronic Components Datasheet Search |
|
FT4232H Datasheet(PDF) 20 Page - Future Technology Devices International Ltd. |
|
|
|||||||||||||||||||||||||||||
FT4232H Datasheet(HTML) 20 Page - Future Technology Devices International Ltd. |
|
20 / 43 page ![]() Copyright © 2009 Future Technology Devices International Limited 20 Document No.: FT_000060 FT4232H QUAD HIGH SPEED USB TO MULTIPURPOSE UART/MPSSE IC Datasheet Version 2.05 Clearance No.: FTDI#78 4.4 MPSSE Interface Mode Description. MPSSE Mode is designed to allow the FT4232H to interface efficiently with synchronous serial protocols such as JTAG, I2C and SPI Bus. It can also be used to program SRAM based FPGA’s over USB. The MPSSE interface is designed to be flexible so that it can be configured to allow any synchronous serial protocol (industry standard or proprietary) to be implemented using the FT4232H. MPSSE is only available on channel A and channel B. MPSSE is fully configurable, and is programmed by sending commands down the data stream. These can be sent individually or more efficiently in packets. MPSSE is capable of a maximum sustained data rate of 30 Mbits/s. When a channel is configured in MPSSE mode, the IO timing and signals used are shown in Figure 4.4 and Table 4.1 . These show timings for CLKOUT=30MHz. CLKOUT can be divided internally to be provide a slower clock. Figure 4.4 MPSSE Signal Waveforms NAME MIN NOM MAX Units COMMENT t1 33.33 ns CLKOUT period t2 15 16.67 ns CLKOUT high period t3 15 16.67 ns CLKOUT low period t4 1 7.15 ns CLKOUT to TDI/DO delay t5 0 ns TDO/DI hold time t6 11 TDO/DI setup time Table 4.1 MPSSE Signal Timings MPSSE mode is enabled using Set Bit Bang Mode driver command. A hex value of 2 will enable it, and a hex value of 0 will reset the device. See application note AN2232L-02, “Bit Mode Functions for the FT2232D” for more details and examples. The MPSSE command set is fully described in application note AN_108 – “Command Processor For MPSSE and MCU Host Bus Emulation Modes”. The following additional application notes are available for configuring the MPSSE : • AN_109 – “Programming Guide for High Speed FTCI2C DLL” • AN_110 – “Programming Guide for High Speed FTCJTAG DLL” • AN_111 – “Programming Guide for High Speed FTCSPI DLL” |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |