7/8

9.

An input clamp capacitor will cause delay in operation at power on. Therefore, it is recommended to use a clamp

capacitor no larger than 0.1 F ( A 0.01F (FZ) ceramic capacitor is recommended).

10. CTL pin is in indeterminate status when left Open. Set it at “H” or “L” level.

11. For superimposed, a 1.7v DC voltage should be applied directly to an input pin.

Application circuit 2/2

BA7653AF/53AFV/52AF

Cautions on use

1.

Numbers and data in entries are representative design values and are not guaranteed values of the items.

2.

Although ROHM is confident that the example application circuit reflects the best possible recommendations, be sure to

verify circuit characteristics for your particular application. Modification of constants for other externally connected circuits

may cause variations in both static and transient characteristics for external components as well as this Rohm IC. Allow

for sufficient margins when determining circuit constants.

3.

Absolute maximum ratings

Use of the IC in excess of absolute maximum ratings, such as the applied voltage or operating temperature range

(Topr), may result in IC damage. Assumptions should not be made regarding the state of the IC (short mode or open

mode) when such damage is suffered. A physical safety measure, such as a fuse, should be implemented when using

the IC at times where the absolute maximum ratings may be exceeded.

4.

GND potential

Ensure a minimum GND pin potential in all operating conditions. Make sure that no pins are at a voltage below the

GND at any time, regardless of whether it is a transient signal or not.

5.

Thermal design

Perform thermal design, in which there are adequate margins, by taking into account the permissible dissipation (Pd)

in actual states of use.

6.

Short circuit between terminals and erroneous mounting

Pay attention to the assembly direction of the ICs. Wrong mounting direction or shorts between terminals, GND, or other

components on the circuits, can damage the IC.

7.

Operation in strong electromagnetic field

Using the ICs in a strong electromagnetic field can cause operation malfunction.

8.

For clamp operation stability

Set the output impedance of the stage before a BA7653AF/53AFV/52AF input pin no more than 1 kŸ.

9.

An input clamp capacitor will cause delay in operation at power on. Therefore, it is recommended to use a clamp

capacitor no larger than 0.1 F ( A 0.01F (FZ) ceramic capacitor is recommended).

Fig.7

Fig.6

BA7653AF/53AFV/52AF

When superimpossion is used

DC1.7V

or

DC1.7V or more

BA7653AF/53AFV/52AF