D201GLY datasheet(45/76 Pages) INTEL

45 / 76 page

Technical Reference

CAUTION

Do not place jumpers on this block in any configuration other than the one described

in Table 19. Other jumper configurations are not supported and could damage the

Desktop Board.

Table 19. Front Panel Audio Header/Jumper Block

Jumper Setting

Configuration

5 and 6

9 and 10

Audio line out and mic in signals are routed to the back panel audio

connectors. The back panel audio connectors are shown in Figure 6 on

page 37.

No jumpers

installed

Table 12 on page 39 lists the names of the signals available on this

connector when no jumpers are installed.

INTEGRATOR’S NOTE

When the jumpers are removed and this connector is used for front panel audio, the

back panel audio line out and mic in connectors are disabled.

2.3.2

BIOS Setup Configuration Jumper Block

This 3-pin jumper block determines the BIOS Setup program’s mode. Table 20

describes the jumper settings for the three modes: normal, configure, and recovery.

When the jumper is set to configuration mode and the computer is powered-up, the

BIOS compares the processor version and the microcode version in the BIOS and

reports if the two match.

Table 20. BIOS Setup Configuration Jumper Settings

Function/Mode Jumper Setting

Configuration

Normal

1-2

32 1

The BIOS uses current configuration information and

passwords for booting.

Configure

2-3

32 1

After the POST runs, Setup runs automatically. The

maintenance menu is displayed.

Recovery

None

32 1

The BIOS attempts to recover the BIOS configuration. A

recovery diskette is required.

D201GLY Datasheet(PDF) 45 Page - Intel Corporation

D201GLY Datasheet(HTML) 45 Page - Intel Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76

Datasheet Download

Link URL