TWR-FRAM datasheet(10/20 Pages) RAMTRON

10 / 20 page

TWR‐FRAM Quick Start Guide

5 Software Instructions

5.1 IAR Embedded Workbench for ARM

To develop on and access the IAR project demos built for the TWR‐K53N512, it is necessary to

download IAR Embedded Workbench for ARM.

Note: Please check that you have the latest version of IAR Embedded Workbench for ARM

installed (i.e. these projects were developed on version 6.4 and are confirmed to NOT work

on version 6.1).

Go to IAR home website (www.iar.com) under the “Software Download” section and download

IAR Embedded Workbench for ARM processors.

Follow the instructions of the install executable.

5.2 Keil µVision4

To develop on and access the Keil project demos built for the TWR‐K53N512, it is necessary to

download Keil µVision4.

Note: Please check that you have the latest version Keil µVision4 for MDK‐ARM installed.

Go to Keil home website (www.keil.com) and select “Product Downloads” under the “Software

Downloads” section. Download Keil MDK‐ARM.

Follow the instructions of the install executable.

You will also need to download and install the Freescale Kinetis OSJTAG drivers for Keil.

(http://www.keil.com/download/docs/408.asp)

5.3 PE Micro OSBDM Virtual Serial Toolkit

This package is used mainly for the drivers to interface with the OSJTAG and its serial terminal

capabilities. A different serial terminal application can be used but it is still necessary to get the

appropriate drivers if it is intended to use the OSJTAG.

Go to the PE Micro OSBDM website (www.pemicro.com/osbdm). Download the package by

following the “OSBDM Virtual Serial Toolkit” link. Use the pdf installation instructions for the

drivers and toolkit by following the link “Installation & Operation of the OSBDM”.

TWR-FRAM Datasheet(PDF) 10 Page - Ramtron International Corporation