ST10F276E datasheet(123/235 Pages) STMICROELECTRONICS

123 / 235 page

ST10F276E

System reset

Doc ID 12303 Rev 3

123/235

Figure 36.

SW / WDT bidirectional RESET (EA = 0) followed by a HW RESET

19.7

Reset circuitry

Internal reset circuitry is described in Figure 39. The RSTIN pin provides an internal pull-up

resistor of 50k

Ω to 250kΩ (The minimum reset time must be calculated using the lowest

value).

It also provides a programmable (BDRSTEN bit of SYSCON register) pull-down to output

internal reset state signal (synchronous reset, watchdog timer reset or software reset).

This bidirectional reset function is useful in applications where external devices require a

reset signal but cannot be connected to RSTOUT pin.

This is the case of an external memory running codes before EINIT (end of initialization)

instruction is executed. RSTOUT pin is pulled high only when EINIT is executed.

The RPD pin provides an internal weak pull-down resistor which discharges external

capacitor at a typical rate of 200

μA. If bit PWDCFG of SYSCON register is set, an internal

pull-up resistor is activated at the end of the reset sequence. This pull-up will charge any

capacitor connected on RPD pin.

The simplest way to reset the ST10F276E is to insert a capacitor C1 between RSTIN pin

and VSS, and a capacitor between RPD pin and VSS (C0) with a pull-up resistor R0 between

RPD pin and VDD. The input RSTIN provides an internal pull-up device equalling a resistor of

50k

Ω to 250kΩ (the minimum reset time must be determined by the lowest value). Select C1

that produce a sufficient discharge time to permit the internal or external oscillator and / or

internal PLL and the on-chip voltage regulator to stabilize.

ST10F276E Datasheet(PDF) 123 Page - STMicroelectronics