CR95HF datasheet(9/63 Pages) STMICROELECTRONICS

Part #	CR95HF

Description	13.56-MHz multi-protocol contactless transceiver IC with SPI and UART serial access

PDF	63 Pages

Scroll/Zoom	100%

Manufacturer	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

9 / 63 page

CR95HF

Power management and operating modes

Doc ID 018669 Rev 8

9/63

3.2

Startup sequence

After the power supply is established at power-on, the CR95HF waits for a low pulse on the

pin IRQ_IN (t1) before automatically selecting the external interface (SPI or UART) and

entering Ready state after a delay (t3).

Figure 5.

Power-up sequence

Note for pin SSI0: - - - SPI selected, –––– UART selected

Pin IRQ_IN low level < 0.2 VPS_Main.

Note:

When CR95HF leaves WFE mode (from Power-up, Hibernate, Sleep or Tag Detector)

following an |RQ_IN/RX low level pulse, this pulse is NOT interpreted as the UART start bit

character.

Figure 4.

CR95HF initialization and operating state change

Supply off

Power-up

POR

Ready

Reader

Tag Detector

(& Calibration )

Sleep

IRQ_IN

Protocol Select

POR sequence

Wake-up event

Hibernate

TimeOut

Tag Detection

Idle command

IRQ_IN

Active

WFE

IRQ_IN

Protocol Select

Serial I/F

selection

SPI

Reset

CR95HF Datasheet(PDF) 9 Page - STMicroelectronics

CR95HF Datasheet(HTML) 9 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63

Datasheet Download

Link URL