MLZ2012A3R3W datasheet(23/68 Pages) TI1

23 / 68 page

www.ti.com

Using the Software: ADS1299 Control Registers and GUI

5.3.3

Normal Electrode Input

The Normal electrode input on the MUX routes the inputs (VINP and VINN) differentially to the internal

PGA, as Figure 17 illustrates. An exception is if the SRB1 bit is set high. If channel is in Normal electrode

mode and SRB1 bit is set high the signal on SRB1 pin is routed to negative inputs of all channels instead

of VINN inputs.

5.3.4

DD Input and the Scope Tab

The MV

DD input option allows the measurement of the supply voltage VS = (AVDD + AVSS)/2 for channels 1,

2, 5, 6, 7, and 8; however, the supply voltage for channel 3 and 4 will be DV

DD/4. As an example, in

bipolar supply mode, AV

DD = 3.0V and AVSS = –2.5V. Therefore, with the PGA gain = 1, the output voltage

measured by the ADC will be approximately 0.25V.

5.3.5

Bias Measurement

This measurement takes the voltage at the BIASIN pin and measures it on the PGA with respect to

(AVDD + AVSS)/2 or BIASREF. This option can be used to give a calibration/test signal to ADS1299

device without connecting the calibration/test signal to the electrodes. The positive signal can be applied

to BIASIN pin and the negative input can be applied to the BIASREF pin. More details on this can be

found in Section 7.3.

5.3.6

Bias Positive Electrode Drive and Bias Negative Electrode

This option can be used to have a selectable bias electrode. This option routes the signal on BIASIN pin

to any of positive or negative pins of the channel inputs.

5.4

GPIO and Other Registers

The GPIO and Other Registers tab, located under the Analysis tab, includes controls for GPIO1 through

GPIO4, SRB1 control, pulse mode control and lead off comparators power down. The GPIO registers

control four general-purpose I/O pins. Figure 23 illustrates the GPIO Control Register GUI panel.

Figure 23. GPIO Control Register GUI Panel

5.5

Lead-Off and BIAS Registers

The Lead-Off Detection and Current Control Registers and the Bias Derivation Control Registers are

located under the ADC Register

→LOFF and BIAS tab.

SLAU443 – May 2012

EEG Front-End Performance Demonstration Kit

Submit Documentation Feedback

MLZ2012A3R3W Datasheet(PDF) 23 Page - Texas Instruments

MLZ2012A3R3W Datasheet(HTML) 23 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68

Datasheet Download

Link URL