WM8768GEDSSLASHV datasheet(12/38 Pages) WOLFSON

12 / 38 page

WM8768

Production Data

PD Rev 4.3 July 2010

INTERNAL POWER ON RESET CIRCUIT

Figure 7 Internal Power on Reset Circuit Schematic

The WM8768 includes an internal Power-On-Reset Circuit, as shown in Figure 7, which is used reset

the digital logic into a default state after power up. The POR circuit is powered from DVDD and

monitors DVDD. It asserts PORB low if DVDD is below a minimum threshold.

Figure 8 Typical Power-Up Sequence

Figure 8 shows a typical power-up sequence. When DVDD goes above the minimum threshold,

Vpord, there is enough voltage for the circuit to guarantee PORB is asserted low and the chip is held

in reset. In this condition, all writes to the control interface are ignored. When DVDD rises to

Vpor_on, PORB is released high and all registers are in their default state and writes to the control

interface may take place.

On power down, PORB is asserted low whenever DVDD drops below the minimum threshold

Vpor_off.

SYMBOL

MIN

TYP

MAX

UNIT

Vpord

0.3

0.5

0.8

Vpor_on

1.3

1.7

2.0

Vpor_off

1.3

1.7

2.0

Table 5 Typical POR Operation (typical values, not tested)

WM8768GEDS/V Datasheet(PDF) 12 Page - Wolfson Microelectronics plc