WM8352 datasheet(157/336 Pages) WOLFSON

157 / 336 page

Production Data

WM8352

PD, February 2011, Rev 4.4

157

17.7 BATTERY CHARGER

17.7.1

GENERAL DESCRIPTION

The WM8352 incorporates a battery charger which is designed for single-cell lithium batteries. The

battery charger can operate from either the Wall (LINE) or USB power sources. Trickle charging at

50mA is enabled by default. The battery charger configuration and termination can run without any

intervention required by the host processor.

The battery charger voltage and currents are programmable. Trickle charging at either 50mA or

100mA is supported; fast charging from 50mA up to 750mA is possible under certain conditions.

Note that charging from the USB power is subject to the 100mA or 500mA overall limit on the USB

source (see Section 17.4).

Battery pack temperature sensing is enabled by default. The connection to the battery’s NTC resistor

is made using the SWVRTC pin and the AUX1 pin, as illustrated in Figure 76. The SWVRTC pin is a

reference source controlled by the WM8352. The AUX1 pin (also an input to the AUXADC) is used as

the input to the temperature sensing circuit. Note that the absence of the NTC connection will lead to

a temperature failure condition being detected and battery charging will not be possible.

Typical connections for the WM8352 battery charger are illustrated in Figure 76. The resistor value

between SWVRTC and AUX1 should be selected to match the NTC. A typical value is 100k

Ω.

Figure 76 Typical Connections for WM8352 Battery Charger

The WM8352 monitors the battery status via the AUX1 pin and by voltage/current sensing on other

pins. See Section 17.7.7 for details of the battery fault conditions and reporting.

If the application is intended to run without a battery present, then it is recommended that a 3.3

μF

capacitor be placed on the BATT pin to ensure correct charger behaviour. In this case, the Battery

Charger interrupts should also be masked, as these will be invalid - see Section 17.7.8 for details of

the Battery Charger Interrupts. It is recommended that the Battery Charger also be disabled in this

case - note that the Battery Charger is enabled by default, including on entry to the OFF power state.

A typical battery charge cycle is illustrated in Figure 77. This shows both the trickle charge and fast

charge processes.

The trickle charge mode is a constant current mode. Trickle charging is enabled when the battery

voltage falls below a charging threshold voltage; it is disabled when the charge current falls to a

programmable ‘End of Charge’ threshold level.

WM8352 Datasheet(PDF) 157 Page - Wolfson Microelectronics plc