18

Dust Networks

LTP5900 Mote Datasheet

10.1.2

FCC-approved Antennae

The following are FCC-approved antenna specifications for the LTP5900.

Table 17

FCC-approved Antenna Specifications for the LTP5900

Gain

Type

Pattern

Polarization

Frequency

Connector

+2 dBi maximum

Dipole

Omni-directional

Vertical

2.4-2.4835 GHz

MMCX

10.1.3

OEM Labeling Requirements

The Original Equipment Manufacturer (OEM) must ensure that FCC labeling requirements are met. The outside of the final

product enclosure must have a label with the following (or similar) text specifying the FCC identifier. The FCC ID and

certification code must be in Latin letters and Arabic numbers and visible without magnification.

Contains transmitter module FCC ID: SJC-LTP5900

Or

Contains FCC ID: SJC-LTP5900

10.2

Industry Canada (IC) Compliance

10.2.1

IC Testing

The LTP5900 is certified for modular Industry Canada (IC) RSS-210 approval. The OEM is responsible for its product to

comply with IC ICES-003 and FCC Part 15, Sub. B - Unintentional Radiators. The requirements of ICES-003 are equivalent

to FCC Part 15 Sub. B and Industry Canada accepts FCC test reports or CISPR 22 test reports for compliance with ICES-003.

10.2.2

IC-approved Antennae

The LTP5900 is designed to operate with antennas meeting the specifications shown in Table 18. Antennas not meeting these

specifications are strictly prohibited for use with the LTP5900. The required antenna impedance is 50 Ohms. Operation is

subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any

interference, including interference that may cause undesired operation of the device.

Table 18

IC-approved Antenna Specifications for the LTP5900

Gain

Type

Pattern

Polarization

Frequency

Connector

+2 dBi maximum

Dipole

Omni-directional

Vertical

2.4-2.4835 GHz

MMCX

10.2.3

OEM Labeling Requirements

The Original Equipment Manufacturer (OEM) must ensure that IC labeling requirements are met. The outside of the final

product enclosure must have a label with the following (or similar) text specifying the IC identifier. The IC ID and

certification code must be in Latin letters and Arabic numbers and visible without magnification

Contains IC: 5853A-LTP5900