DP83848JSQ datasheet(53/80 Pages) TI

53 / 80 page

www.national.com

7.2.5 RMII and Bypass Register (RBR)

This register configures the RMII Mode of operation. When RMII mode is disabled, the RMII functionality is bypassed.

Table 25. RMII and Bypass Register (RBR), addresses 0x17

Bit

Bit Name

Default

Description

15:6

RESERVED

0, RO

RESERVED: Writes ignored, Read as 0.

RMII_MODE

Strap, RW

Reduced MII Mode:

0 = Standard MII Mode

1 = Reduced MII Mode

RMII_REV1_0

0, RW

Reduce MII Revision 1.0:

0 = (RMII revision 1.2) CRS_DV will toggle at the end of a packet

to indicate deassertion of CRS.

1 = (RMII revision 1.0) CRS_DV will remain asserted until final data

is transferred. CRS_DV will not toggle at the end of a packet.

RX_OVF_STS

0, RO

RX FIFO Over Flow Status:

0 = Normal

1 = Overflow detected

RX_UNF_STS

0,RO

RX FIFO Under Flow Status:

0 = Normal

1 = Underflow detected

1:0

ELAST_BUF[1:0]

1, RW

Receive Elasticity Buffer. This field controls the Receive Elastic-

ity Buffer which allows for frequency variation tolerance between

the 50MHz RMII clock and the recovered data. The following value

indicate the tolerance in bits for a single packet. The minimum set-

ting allows for standard Ethernet frame sizes at +/-50ppm accuracy

for both RMII and Receive clocks. For greater frequency tolerance

the packet lengths may be scaled (i.e. for +/-100ppm, the packet

lengths need to be divided by 2).

00 = 14 bit tolerance (up to 16800 byte packets)

01 = 2 bit tolerance (up to 2400 byte packets)

10 = 6 bit tolerance (up to 7200 byte packets)

11 = 10 bit tolerance (up to 12000 byte packets)

DP83848JSQ Datasheet(PDF) 53 Page - Texas Instruments

DP83848JSQ Datasheet(HTML) 53 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80

Datasheet Download

Link URL