LMV358MM datasheet(14/45 Pages) NSC

14 / 45 page

LMV321-N, LMV321-N-Q1, LMV358-N, LMV358-N-Q1

LMV324-N, LMV324-N-Q1

SNOS012I – AUGUST 2000 – REVISED FEBRUARY 2013

www.ti.com

APPLICATION INFORMATION

BENEFITS OF THE LMV321-N/LMV358-N/LMV324-N

Size

The small footprints of the LMV321-N/LMV358-N/LMV324-N packages save space on printed circuit boards, and

enable the design of smaller electronic products, such as cellular phones, pagers, or other portable systems. The

low profile of the LMV321-N/LMV358-N/LMV324-N make them possible to use in PCMCIA type III cards.

Signal Integrity

Signals can pick up noise between the signal source and the amplifier. By using a physically smaller amplifier

package, the LMV321-N/LMV358-N/LMV324-N can be placed closer to the signal source, reducing noise pickup

and increasing signal integrity.

Simplified Board Layout

These products help you to avoid using long PC traces in your PC board layout. This means that no additional

components, such as capacitors and resistors, are needed to filter out the unwanted signals due to the

interference between the long PC traces.

Low Supply Current

These devices will help you to maximize battery life. They are ideal for battery powered systems.

Low Supply Voltage

Texas Instruments provides guaranteed performance at 2.7V and 5V. These guarantees ensure operation

throughout the battery lifetime.

Rail-to-Rail Output

Rail-to-rail output swing provides maximum possible dynamic range at the output. This is particularly important

when operating on low supply voltages.

Input Includes Ground

Allows direct sensing near GND in single supply operation.

Protection should be provided to prevent the input voltages from going negative more than

−0.3V (at 25°C). An

input clamp diode with a resistor to the IC input terminal can be used.

Ease of Use and Crossover Distortion

The LMV321-N/LMV358-N/LMV324-N offer specifications similar to the familiar LM324-N. In addition, the new

LMV321-N/LMV358-N/LMV324-N effectively eliminate the output crossover distortion. The scope photos in

Figure 49 and Figure 50 compare the output swing of the LMV324-N and the LM324-N in a voltage follower

configuration, with VS = ± 2.5V and RL (= 2 kΩ) connected to GND. It is apparent that the crossover distortion

has been eliminated in the new LMV324-N.

Figure 49. Output Swing of LMV324

Submit Documentation Feedback

Product Folder Links: LMV321-N LMV321-N-Q1 LMV358-N LMV358-N-Q1 LMV324-N LMV324-N-Q1

LMV358MM Datasheet(PDF) 14 Page - National Semiconductor (TI)