Device description

M27C801

8/24

2

Device description

The operating modes of the M27C801 are listed in the Operating Modes table. A single

on A9 for Electronic Signature and Margin Mode Set or Reset.

2.1

Read mode

The M27C801 has two control functions, both of which must be logically active in order to

obtain data at the outputs. Chip Enable (E) is the power control and should be used for

device selection. Output Enable (G) is the output control and should be used to gate data to

the output pins, independent of device selection. Assuming that the addresses are stable,

2.2

Standby mode

The M27C801 has a standby mode which reduces the supply current from 35mA to 100µA.

The M27C801 is placed in the standby mode by applying a CMOS high signal to the E input.

When in the standby mode, the outputs are in a high impedance state, independent of the

2.3

Two-line output control

Because EPROMs are usually used in larger memory arrays, the product features a 2 line

control function which accommodates the use of multiple memory connection. The two line

control function allows:

●

the lowest possible memory power dissipation,

●

complete assurance that output bus contention will not occur.

For the most efficient use of these two control lines, E should be decoded and used as the

primary device selecting function, while G should be made a common connection to all

devices in the array and connected to the READ line from the system control bus. This

Table 2.

1.

Mode

E

A9

Q7-Q0

Read

XData Out

Output Disable

X

Hi-Z

Program

X

Data In

Program Inhibit

X

Hi-Z

Standby

X

X

Hi-Z

Electronic signature

Codes

Obsolete

Product(s)

- Obsolete

Product(s)