UM1488

Getting started

Doc ID 022451 Rev 2

5/17

3

Getting started

To start working with an STPMC1 demonstration board, follow the steps below:

1.

Connect the demonstration board to the parallel hardware programmer or to the serial

programmer (STEVAL-IPE005V1)

2.

Connect the programmer to the PC through a parallel or serial cable

3.

Power on the demonstration board (and eventually the serial programmer)

4.

Open STPMC1 Evaluation Software

5.

Select the menu Option - Interface - Parallel or Serial according to the chosen

hardware programmer (see Section 4.2)

6.

Configure the application parameters selecting Option - Configuration menu (see

Section 4.2)

7.

The user is now ready to Read, Write (see Section 5.5) or Calibrate the application

(see Section 4.3).