ACT4524

Rev 0, 28-Jul-15

Innovative Power

TM

- 2 -

www.active-semi.com

Copyright © 2015 Active-Semi, Inc.

ORDERING INFORMATION

PART NUMBER

OPERATION AMBIENT TEMPERA-

TURE RANGE

PACKAGE

PACKING

ACT4524YH-T

-40°C to 85°C

SOP-8EP

TAPE & REEL

PIN CONFIGURATION

PIN DESCRIPTIONS

PIN

NAME

DESCRIPTION

1

CSP

Voltage Feedback Input. The voltage at this pin is regulated to 5.10V. Connect this pin to the

positive terminal of current sense resistor. CSP, CSN1 and CSN2 Kevin sense is

recommended.

2

CSN1 Output current sense. Connect to the negative terminal of current sense resistor for VOUT1.

3

CSN2 Output current sense. Connect to the negative terminal of current sense resistor for VOUT2.

4

MODE

Mode pin with internal pull up current to determine device should operate in Native, Master,

or Slave mode. If the pin is floated, the device operates in native mode; if the pin is

grounded ,the device operates in Slave mode and receives CLK signal from another device;

if the pin is connected to 82kOhm resistor, the device is configured in Master mode.

5

CLK

Synchronization of dual chips. Two chips operate synchronously out of phase with CLK pin

connected.

6

IN

Power Supply Input. Bypass this pin with a 10μF ceramic capacitor to GND, placed as close

to the IC as possible.

7

SW

Power switching output to external inductor.

8

HSB

High Side Bias pin. This pin provides power to the internal high-side MOSFET gate driver.

Connect a 22nF capacitor from HSB pin to SW pin.

9

GND

Ground and heat dissipation pad. Connect this exposed pad to large ground copper area

and other ground planes by thermal vias.

Top View