LMP8602MASLASHNOPB datasheet(31/42 Pages) TI1

31 / 42 page

LMP8601, LMP8601-Q1

LMP8602, LMP8602-Q1

LMP8603, LMP8603-Q1

www.ti.com

SNOSAR2H – SEPTEMBER 2008 – REVISED APRIL 2016

Product Folder Links: LMP8601 LMP8601-Q1 LMP8602 LMP8602-Q1 LMP8603 LMP8603-Q1

Submit Documentation Feedback

9 Power Supply Recommendations

In order to decouple the LMP860x and LMP860x-Q1 from AC noise on the power supply, place a 0.1-

μF bypass

capacitor between the VS and GND pins. Place this capacitor as close as possible to the supply pins. In some

cases, an additional 10-

μF bypass capacitor may further reduce the supply noise.

10 Layout

10.1 Layout Guidelines

The traces leading to and from the sense resistor can be significant error sources. With small value sense

resistors (< 100 m

Ω), any trace resistance shared with the load current can cause significant errors.

The amplifier inputs should be directly connected to the sense resistor pads using Kelvin or 4-wire connection

techniques. The traces should be one continuous piece of copper from the sense resistor pad to the amplifier

input pin pad, and ideally on the same copper layer with minimal vias or connectors. This can be important

around the sense resistor if it is generating any significant heat gradients.

To minimize noise pickup and thermal errors, the input traces should be treated as a differential signal pair and

routed tightly together with a direct path to the input pins. The input traces should be run away from noise

sources, such as digital lines, switching supplies or motor drive lines. Remember that these traces can contain

high voltage, and should have the appropriate trace routing clearances.

Since the sense traces only carry the amplifier bias current, the connecting input traces can be thinner, signal

level traces. Excessive Resistance in the trace should also be avoided.

The paths of the traces should be identical, including connectors and vias, so that any errors will be equal and

cancel.

The sense resistor will heat up as the load increases. As the resistor heats up, the resistance generally goes up,

which will cause a change in the readings. The sense resistor should have as much heatsinking as possible to

remove this heat through the use of heatsinks or large copper areas coupled to the resistor pads. A reading

drifting over time after turnon can usually be traced back to sense resistor heating.

10.2 Layout Example

Figure 66. Kelvin or 4–wire Connection to the Sense Resistor

LMP8602MA/NOPB Datasheet(PDF) 31 Page - Texas Instruments