DS1086 Spread-Spectrum EconOscillator

_____________________________________________________________________

9

The output frequency is determined by the following

equation:

where: min frequency of selected OFFSET range is the

ing offset).

DAC value is the value of the DAC register (0 to 1023).

See the Example Frequency Calculations section for a

more in-depth look at using the registers.

________________Register Definitions

The DS1086 registers are used to determine the output

frequency and dither amount. A summary of the regis-

tings below, the default output frequency is 97.1MHz.

See the Example Frequency Calculations section for an

example on how to determine the register settings for a

desired output frequency.

PRESCALER Register

The PRESCALER register controls the prescaler (bits P3

to P0) and dither (bit J0). The prescaler divides the mas-

Any prescaler value entered that is greater than 8

decodes as 8. The dither applied to the output is con-

trolled with bit J0. When J0 is high, 2% peak dither is

selected. When J0 is low, 4% peak dither is selected.

DAC HIGH/DAC LOW Register

The 2-byte DAC register sets the frequency of the master

oscillator to a particular value within the current offset

range. Each step of the DAC changes the master oscilla-

tor frequency by 10kHz. The first byte is the MSB (DAC

HIGH) and the second byte is the LSB (DAC LOW).

OFFSET Register

The OFFSET register determines the range of frequencies

that can be obtained for a given DAC setting. The factory

default offset is copied into the RANGE register so the

user can access the default offset after making changes

Correct operation of the device is not guaranteed out-

side the range 66MHz to 133MHz.

MIN FREQUENCY OF SELECTED OFFSET RANGE

DAC VALUE

kHz STEP SIZE

PRESCALER

(

)

(

)

=

+× 10

SDA

SCL

2-WIRE

INTERFACE

DAC

OFFSET

EEPROM CONTROL

REGISTERS

PRESCALER

ADDR

RANGE

SPRD

PDN

OUT

OE

DAC

TRIANGLE WAVE

GENERATOR

VOLTAGE-CONTROLLED

OSCILLATOR

PRESCALER

BY 1, 2, 4...256

GND

MASTER

OSCILLATOR

OUTPUT

DITHER SIGNAL

DITHER

CONTROL

FREQUENCY

CONTROL VOLTAGE

DS1086

Figure 3. DS1086 Block Diagram

(1)