LPC2292 datasheet(28/40 Pages) PHILIPS

28 / 40 page

Philips Semiconductors

LPC2292/LPC2294

16/32-bit ARM microcontrollers with external memory interface

Preliminary data

Rev. 01 — 05 February 2004

28 of 40

9397 750 12748

[1]

The following applies to the Limiting values:

a) Stresses above those listed under Limiting values may cause permanent damage to the device.

This is a stress rating only and functional operation of the device at these or any conditions other

than those described in Section 8 “Static characteristics” and Section 9 “Dynamic characteristics”

of this speciﬁcation is not implied.

b) This product includes circuitry speciﬁcally designed for the protection of its internal devices from

the damaging effects of excessive static charge. Nonetheless, it is suggested that conventional

precautions be taken to avoid applying greater than the rated maximum.

c) Parameters are valid over operating temperature range unless otherwise speciﬁed. All voltages

are with respect to VSS unless otherwise noted.

[2]

Not to exceed 4.6 V.

[3]

Including voltage on outputs in 3-state mode.

[4]

Only valid when the V3 supply voltage is present.

[5]

The peak current is limited to 25 times the corresponding maximum current.

[6]

Dependent on package type.

DC supply current per supply pin[5]

100

DC ground current per ground pin[5]

100

Tstg

Storage temperature[6]

−40

125

°C

Power dissipation (based on

package heat transfer, not device

power consumption)

1.5

Table 9:

Limiting values…continued

In accordance with the Absolute Maximum Rating System (IEC 60134).

Symbol

Parameter

Conditions

Min

Max

Unit

LPC2292 Datasheet(PDF) 28 Page - NXP Semiconductors

LPC2292 Datasheet(HTML) 28 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Datasheet Download

Link URL