| Electronic Components Datasheet Search |
|
CS61535A Datasheet(PDF) 24 Page - Cirrus Logic |
|
|
|||||||||||||||||||||||||||||
CS61535A Datasheet(HTML) 24 Page - Cirrus Logic |
|
24 / 48 page ![]() Power Supplies RGND - Ground, Pin 22. Power supply ground for all subcircuits except the transmit driver; typically 0 Volts. RV+ - Power Supply, Pin 21. Power supply for all subcircuits except the transmit driver; typically +5 Volts. TGND - Ground, Transmit Driver, Pin 14. Power supply ground for the transmit driver; typically 0 Volts. TV+ - Power Supply, Transmit Driver, Pin 15. Power supply for the transmit driver; typically +5 Volts. TV+ must not exceed RV+ by more than 0.3 V. Oscillator XTALIN, XTALOUT - Crystal Connections, Pins 9 and 10. A 6.176 MHz (or 8.192 MHz) crystal should be connected across these pins. If a 1.544 MHz (or 2.048 MHz) clock is provided on ACLKI (pin 1), the jitter attenuator may be disabled by tying XTALIN, Pin 9 to RV+ through a 1 k Ω resistor, and floating XTALOUT, Pin 10. Overdriving the oscillator with an external clock is not supported. Control ACLKI - Alternate External Clock Input, Pin 1. The CS61535A does not require a clock signal to be input on ACLKI when a crystal is connected between pins 9 and 10. If a clock is not provided on ACLKI, this input must be grounded. If ACLKI is grounded, the oscillator in the jitter attenuator is used to calibrate the clock recovery circuit and TAOS is not available. CLKE - Clock Edge, Pin 28. (Host Mode) Setting CLKE to logic 1 causes RPOS and RNEG to be valid on the falling edge of RCLK, and SDO to be valid on the rising edge of SCLK. Conversely, setting CLKE to logic 0 causes RPOS and RNEG to be valid on the rising edge of RCLK, and SDO to be valid on the falling edge of SCLK. CS - Chip Select, Pin 26. (Host Mode) This pin must transition from high to low to read or write the serial port. INT - Receive Alarm Interrupt, Pin 23. (Host Mode) Goes low when LOS or DPM change state to flag the host processor. INT is cleared by writing "Clear LOS" or "Clear DPM" to the register. INT is an open drain output and should be tied to the power supply through a resistor. CS61535A 24 DS40F1 |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |