WM8750LEFLSLASHR datasheet(43/56 Pages) WOLFSON

43 / 56 page

Product Preview

WM8750L

PP Rev 1.77 May 2003

The WM8750L has two possible device addresses, which can be selected using the CSB pin.

CSB STATE

DEVICE ADDRESS

Low

0011010 (0 x 34h)

High

0011011 (0 x 36h)

Table 39 2-Wire MPU Interface Address Selection

POWER SUPPLIES

The WM8750L can use up to four separate power supplies:

•

AVDD / AGND: Analogue supply, powers all analogue functions except the headphone drivers.

AVDD can range from 1.8V to 3.6V and has the most significant impact on overall power

consumption (except for power consumed in the headphone). A large AVDD slightly improves

audio quality.

•

HPVDD / HPGND: Headphone supply, powers the headphone drivers. HPVDD can range from

1.8V to 3.6V. HPVDD is normally tied to AVDD, but it requires separate layout and decoupling

capacitors to curb harmonic distortion. With a larger HPVDD, louder headphone and speaker

outputs can be achieved with lower distortion. If HPVDD is lower than AVDD, the output signal

may be clipped.

•

DCVDD: Digital core supply, powers all digital functions except the audio and control

interfaces. DCVDD can range from 1.42V to 3.6V, and has no effect on audio quality. The

return path for DCVDD is DGND, which is shared with DBVDD.

•

DBVDD: Digital buffer supply, powers the audio and control interface buffers. This makes it

possible to run the digital core at very low voltages, saving power, while interfacing to other

digital devices using a higher voltage. DBVDD draws much less power than DCVDD, and has

no effect on audio quality. DBVDD can range from 1.8V to 3.6V. The return path for DBVDD is

DGND, which is shared with DCVDD.

It is possible to use the same supply voltage on all four. However, digital and analogue supplies

should be routed and decoupled separately to keep digital switching noise out of the analogue signal

paths.

WM8750LEFL/R Datasheet(PDF) 43 Page - Wolfson Microelectronics plc