| Electronic Components Datasheet Search |
|
QT20.361 Datasheet(PDF) 7 Page - PULS GmbH |
|
|
|||||||||||||||||||||||||||||
QT20.361 Datasheet(HTML) 7 Page - PULS GmbH |
|
7 / 23 page ![]() QT20.361 Q-Series 36V, 13.3A, THREE PHASE INPUT Oct. 2006 / Rev. 1.0 DS-QT20.361-EN All parameters are specified at 36V, 13.3A, 3x400Vac, 25°C ambient and after a 5 minutes run-in time unless otherwise noted. www.pulspower.com Phone +49 89 9278 0 Germany 9. HOLD-UP TIME 3AC 400V 3AC 480V Hold-up Time typ. 22ms 22ms 13.3A, 36V, see Fig. 9-1 typ. 44ms 44ms 6.7A, 36V, see Fig. 9-1 Fig. 9-1 Hold-up time vs. input voltage Fig. 9-2 Shut-down behavior, definitions 0 10 20 30 40 50ms 320 360 400 440 3x480Vac Input Voltage Hold-up Time 36V, 6.7A, typ. 36V, 13.3A, typ. 36V, 6.7A, min. 36V, 13.3A, min. - 5% Hold-up Time Zero Transition Output Voltage Intput Voltage 10. DC-OK RELAY CONTACT This feature monitors the output voltage, which is produced by the power supply itself. It is independent of a back- fed voltage from a unit which is connected in parallel to the power supply output. Contact closes As soon as the output voltage reaches the adjusted output voltage. Contact opens As soon as the output voltage dips more than 10% below the adjusted output voltage. Short dips will be extended to a signal length of 250ms. Dips shorter than 1ms will be ignored. Contact re-closes As soon as the output voltage exceeds 90% of the adjusted voltage. Contact ratings max 60Vdc 0.3A, 30Vdc 1A, 30Vac 0.5A resistive load min 1mA at 5Vdc min. permissible load Isolation voltage See dielectric strength table in section 20 Fig. 10-1 DC-ok relay contact behavior 250ms 90% V ADJ < 1ms 10% open V OUT= VADJ open closed closed > 1ms Note: The DC-ok feature requires that the output voltage reaches the nominal (=adjusted) level after turn-on in order to function according to specification. If this level cannot be achieved, the overload lamp will be on and the DC-ok contact will be open. The overload signal will only shut off as soon as the adjusted voltage is reached. This is an important condition to consider particularly, if the load is a battery, the power supply is used in parallel or the power supply is used for N+1 redundant systems. 7/23 |
|
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |