UM0285 datasheet(8/32 Pages) STMICROELECTRONICS

8 / 32 page

EK3LV02DL GUI installation

UM0285

8/32

EK3LV02DL GUI installation

The installation of Graphical User Interface (GUI) for the EK3LV02DL implies two steps:

–

the installation onto the PC of the Software delivered with the evaluation kit;

–

the installation of the Virtual COM driver needed to use the Evaluation Kit board.

2.1

PC system requirements

Both the hardware and software that compose the EK3LV02DL Evaluation Software Kit have

been designed to operate with:

–

Microsoft® Windows® XP®;

–

Microsoft.NET Framework 1.1 (or higher); this software can be downloaded for

free from the Microsoft web site (a). The installation of the “Microsoft.NET

Framework” is not required when running on windows XP SP2 or higher.

2.2

Software installation

To install the SW distributed along with the EK3LV02DL evaluation kit:

Insert the MiniCD delivered with the Kit inside the CD-ROM drive

If the Autorun screen does not appear, click on Start > Run, enter “D:\Autorun.exe”

and click OK. “D” represents the letter of your CD-ROM drive.

Click onto “Evaluation Kit SW Installation” from the “EK3LV02DL Evaluation Kit” page

which appears;

Follow the instructions given by the Installer (Figure 4).

Figure 4.

Software installation

http://www.microsoft.com/downloads and search for.Net framework Redistributable Package.

UM0285 Datasheet(PDF) 8 Page - STMicroelectronics