UM1059

Getting started

DocID018518 Rev 2

7/9

3

Getting started

3.1

Board connection

Plug in one or more STEVAL-IPE014V1, using the connectors DAR, DAS, DAT, and DAN

(optional for 4-wire with tamper system), as shown in Figure 3: "STEVAL-IPE010V2

daughterboard assembly":

Figure 3: STEVAL-IPE010V2 daughterboard assembly

3.2

System configuration

Once one or more STEVAL-IPE014V1 boards are plugged into the STEVAL-IPE010V2

board and powered on, the system must be programmed and configured through the

STPMC1 GUI.

The basic STPMC1 configuration bits to be set are the following:

TCS = 1: current transformer sensor selected

PM = 1: the STPMS2 device selected for precision mode

HSA = 1: high speed clock output for the STPMS2 device

Please, note that these boards are not neither programmed and nor calibrated.

To calibrate the system, first set the calibrator value to the middle of the range, setting

CVX7 = 1 and CIX7 = 1 (where X stands for R, S, T, or N according to the phase the

STPMS2 board is plugged into).

To complete the calibration, use the STPMC1 GUI and follow the procedure described in

AN3398.