STM32F410RB datasheet(112/142 Pages) STMICROELECTRONICS

112 / 142 page

Electrical characteristics

STM32F410x8/B

112/142

DocID028094 Rev 5

Note:

ADC accuracy vs. negative injection current: injecting a negative current on any analog

input pins should be avoided as this significantly reduces the accuracy of the conversion

being performed on another analog input. It is recommended to add a Schottky diode (pin to

ground) to analog pins which may potentially inject negative currents.

Any positive injection current within the limits specified for IINJ(PIN) and ΣIINJ(PIN) in

Section 6.3.16 does not affect the ADC accuracy.

Figure 37. ADC accuracy characteristics

1. See also Table 68.

2. Example of an actual transfer curve.

3. Ideal transfer curve.

4. End point correlation line.

5. ET = Total Unadjusted Error: maximum deviation between the actual and the ideal transfer curves.

EO = Offset Error: deviation between the first actual transition and the first ideal one.

EG = Gain Error: deviation between the last ideal transition and the last actual one.

ED = Differential Linearity Error: maximum deviation between actual steps and the ideal one.

EL = Integral Linearity Error: maximum deviation between any actual transition and the end point

correlation line.

STM32F410RB Datasheet(PDF) 112 Page - STMicroelectronics