Wiring Diagrams

3

1

2

4

5

10-30V dc

Remote

Teach

Load

Load

+

–

Key

1 = Brown

2 = White

3 = Blue

4 = Black

5 = Gray

Quick disconnect (QD) wiring diagrams are functionally identical.

Sensor Configuration

The R58E is pre-set to power up in Run mode and to sense the most recently taught registration mark. Quickly optimize the sensitivity of

the R58E using one of two available TEACH modes: Static TEACH or Dynamic TEACH.

Static TEACH: Both the Output ON and Output OFF conditions are presented, and sensitivity can be adjusted manually using the push

buttons.

Dynamic TEACH: The registration mark is presented during actual sensing conditions, and the sensitivity can be adjusted manually using

the push buttons.

Remote TEACH

Configure the sensor either using the push buttons, or using a remote switch. Remote configuration also may be used to enter Setup

mode to set the ON- and OFF-delay, and to disable the push buttons to prevent unauthorized adjustment of the configuration settings.

To access this feature, connect the gray wire of the sensor to 0 V dc, with a remote switch between the sensor and 0 V dc.

Follow the sequence of input pulses to configure the sensor (see the procedures in this document). The duration of each pulse

(corresponding to a push button “click”), and the period between multiple pulses, are defined as: “T”: 0.04 seconds ≤ “T” ≤ 0.8 seconds.

Push Button Enable/Disable (Lockout)

In addition to its configuration function, the remote input may be used to disable the push buttons for security. Disabling the push

buttons prevents unauthorized adjustment of the configuration settings. Connect the gray wire of the sensor as described in Wiring

Diagrams on page 4, and four-pulse to either enable or disable the push buttons (0.04 seconds < "T" < 0.8 seconds):

Note: Push buttons can be disabled/enabled from the remote line only.

Static TEACH

In Static TEACH mode, the sensor learns two sensing conditions after each is presented one time. The sensor automatically positions the

switchpoint midway between the two conditions.

The sensor returns to Run mode if either TEACH condition is not

registered within 60 seconds. The sensor reverts to the previous

taught conditions.

Cancel TEACH mode by pressing and holding the Static push

button for ≥ 2 seconds. The sensor reverts to the previous taught

conditions (that is, exit without saving).

Static TEACH and Manual Adjust

Sensitivity may be adjusted at any time when the sensor is in Run

mode by clicking the “+” and “-” buttons. Each click translates to

1/2 segment on the signal strength bargraph display. For best

sensing reliability, both sensing conditions should register equally

distant from the switchpoint on the signal strength bargraph

display.

Sensor positions

threshold midway

between taught conditions

Output OFF

Output ON

2nd Taught

Condition

1st Taught

Condition

Position

adjusted by

Manual Adjust

Figure 5. Static TEACH (Light Operate Shown)

4

www.bannerengineering.com - Tel: +1-763-544-3164

P/N 122928 Rev. D