STM32WB55CCV6ATR datasheet(49/193 Pages) STMICROELECTRONICS

49 / 193 page

DS11929 Rev 10

49/193

STM32WB55xx STM32WB35xx

Functional overview

3.18

Liquid crystal display controller (LCD)

The STM32WB55xx devices embed an LCD controller with the following characteristics:



Highly flexible frame rate control.



Supports Static, 1/2, 1/3, 1/4 and 1/8 duty.



Supports Static, 1/2, 1/3 and 1/4 bias.



Double buffered memory allows data in LCD_RAM registers to be updated at any time

by the application firmware without affecting the integrity of the data displayed.

–

LCD data RAM of up to 16 x 32-bit registers which contain pixel information

(active/inactive)



Software selectable LCD output voltage (contrast) from VLCDmin to VLCDmax.



No need for external analog components:

–

A step-up converter is embedded to generate an internal VLCD voltage higher

than VDD (up to 3.6 V if VDD > 2.0 V)

–

Software selection between external and internal VLCD voltage source. In case of

an external source, the internal boost circuit is disabled to reduce power

consumption

–

A resistive network is embedded to generate intermediate VLCD voltages

–

The structure of the resistive network is configurable by software to adapt the

power consumption to match the capacitive charge required by the LCD panel

–

Integrated voltage output buffers for higher LCD driving capability.



The contrast can be adjusted using two different methods:

–

When using the internal step-up converter, the software can adjust VLCD between

VLCDmin and VLCDmax

–

Programmable dead time (up to eight phase periods) between frames.



Full support of low-power modes: the LCD controller can be displayed in Sleep,



Low-power run, Low-power sleep and Stop modes, or can be fully disabled to reduce

power consumption.



Built in phase inversion for reduced power consumption and EMI (electromagnetic

interference).



Start of frame interrupt to synchronize the software when updating the LCD data RAM.



Blink capability:

–

1, 2, 3, 4, 8 or all pixels can be programmed to blink at a configurable frequency

–

Software adjustable blink frequency to achieve around 0.5 Hz, 1 Hz, 2 Hz or 4 Hz.

Used LCD segment and common pins should be configured as GPIO alternate functions

and unused segment and common pins can be used for general purpose I/O or for another

peripheral alternate function.

Note:

When the LCD relies on the internal step-up converter, the VLCD pin should be connected

to VSS with a capacitor. Its typical value is 1 μF.

3.19

True random number generator (RNG)

The devices embed a true RNG that delivers 32-bit random numbers generated by an

integrated analog circuit.

STM32WB55CCV6ATR Datasheet(PDF) 49 Page - STMicroelectronics

STM32WB55CCV6ATR Datasheet(HTML) 49 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL