SN10 datasheet(68/98 Pages) ETC1

68 / 98 page

ILEC SN10 User Manual

Assigned Area Task (AAT)

The SN10 uses the adjusted turnpoints for planning the task, including calculating ETF

d the turnpoints. Normally, you adjust

ght. As you modify your plan during the

it looks like you should turn now to shorten the task

SN10 will

d on the next

ecide to turn towards the next turnpoint, you must tell the SN10. Place the cursor on

(Estimated Time to Finish) and final-glide aroun

the turnpoints on the ground for your planned fli

flight, you may adjust the turnpoint locations in order to get updated ETF and final glide

information.

8.4 AAT In Flight

When you fly into each AAT area on the task, the

SN10 notifies you and gives you the opportunity to

turn at this instant. If the weather is looking poor and

as much as possible, press

ENTER and

mark and record that point then procee

leg.

Normally, you will probably fly some distance into

each turn area; in this case press

HELP when you see

his message. When you later

‘a

e turnpoint (for example AAT Pt1,on the task page, status page, or custom page), and

ress

ENTER. The SN10 will update the present turnpoint to your current location, mark it

chieved’, redraw the moving map, and recalculate the ETF and final glide.

• If you do not turn at the edge

notify you when you reach th

you decide to turn.

8.5 AAT Notes

Answers to a few common AAT qu stions:

of the AAT area, the SN10 will not automatically

e planned turnpoint. You must tell the SN10 when

• The SN10 creates automatic

Pt1

and so on. These points are

henever you create or edit an

AAT. They will appear in your list of turnpoints but should be ignored. They can

contests use a final steering turnpoint, for example to ensure all finishers

d small radius.

P mode. You should switch back to

l the SN10 setup pages.

turnpoint entries in your database named AAT

automatically set w

be deleted from the SN10 database if you like.

• Some

come from the same direction or to steer

enter an AAT cylinder area with the specifie

• You can only change the AAT areas in SETU

flight mode after entering an AAT to hide al

around illegal airspace. In this case, just

Software Version 2.31

Manual Revised 13-Dec-2005

Page 61 of 91

SN10 Datasheet(PDF) 68 Page - List of Unclassifed Manufacturers

SN10 Datasheet(HTML) 68 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98

Datasheet Download

Link URL