PCIMX6DP7AYM2AB datasheet(6/166 Pages) NXP

6 / 166 page

i.MX 6DualPlus/6QuadPlus Automotive Applications Processors, Rev. 3, 11/2018

NXP Semiconductors

Introduction

— Parallel Camera port (up to 20 bit and up to 240 MHz peak)

— MIPI CSI-2 serial camera port, supporting up to 1000 Mbps/lane in 1/2/3-lane mode and up to

800 Mbps/lane in 4-lane mode. The CSI-2 Receiver core can manage one clock lane and up to

four data lanes. Each i.MX 6DualPlus/6QuadPlus processor has four lanes.

•

Expansion cards:

— Four MMC/SD/SDIO card ports all supporting:

– 1-bit or 4-bit transfer mode specifications for SD and SDIO cards up to UHS-I SDR-104

mode (104 MB/s max)

– 1-bit, 4-bit, or 8-bit transfer mode specifications for MMC cards up to 52 MHz in both SDR

and DDR modes (104 MB/s max)

•USB:

— One High Speed (HS) USB 2.0 OTG (Up to 480 Mbps), with integrated HS USB PHY

— Three USB 2.0 (480 Mbps) hosts:

– One HS host with integrated High Speed PHY

– Two HS hosts with integrated High Speed Inter-Chip (HS-IC) USB PHY

•

Expansion PCI Express port (PCIe) v2.0 one lane

— PCI Express (Gen 2.0) dual mode complex, supporting Root complex operations and Endpoint

operations. Uses x1 PHY configuration.

•

Miscellaneous IPs and interfaces:

— SSI block capable of supporting audio sample frequencies up to 192 kHz stereo inputs and

outputs with I2S mode

— ESAI is capable of supporting audio sample frequencies up to 260 kHz in I2S mode with

7.1 multi channel outputs

— Five UARTs, up to 5.0 Mbps each:

– Providing RS232 interface

– Supporting 9-bit RS485 multidrop mode

– One of the five UARTs (UART1) supports 8-wire while the other four support 4-wire. This

is due to the SoC IOMUX limitation, because all UART IPs are identical.

— Five eCSPI (Enhanced CSPI)

— Three I2C, supporting 400 kbps

— Gigabit Ethernet Controller (IEEE1588 compliant), 10/100/10001 Mbps

— Four Pulse Width Modulators (PWM)

— System JTAG Controller (SJC)

— GPIO with interrupt capabilities

— 8x8 Key Pad Port (KPP)

— Sony Philips Digital Interconnect Format (SPDIF), Rx and Tx

— Two Controller Area Network (FlexCAN), 1 Mbps each

1. The theoretical maximum performance of 1 Gbps ENET is limited to 470 Mbps (total for Tx and Rx) due to internal bus

throughput limitations. The actual measured performance in optimized environment is up to 400 Mbps. For details, see the

ERR004512 erratum in the i.MX 6Dual/6Quad errata document (IMX6DQCE).

PCIMX6DP7AYM2AB Datasheet(PDF) 6 Page - NXP Semiconductors

PCIMX6DP7AYM2AB Datasheet(HTML) 6 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL