STM32WB55 datasheet(55/193 Pages) STMICROELECTRONICS

55 / 193 page

DS11929 Rev 11

55/193

STM32WB55xx STM32WB35xx

Functional overview

extremely low energy consumption. Higher speed clock can be used to reach higher

baudrates.

The LPUART interfaces can be served by the DMA controller.

3.25

Serial peripheral interface (SPI1, SPI2)

Two SPI interfaces enable communication up to 32 Mbit/s in master and up to 24 Mbit/s in

slave modes, in half-duplex, full-duplex and simplex modes. The 3-bit prescaler gives 8

master mode frequencies and the frame size is configurable from 4 bits to 16 bits. The SPI

interfaces support NSS pulse mode, TI mode and Hardware CRC calculation.

The SPI interfaces can be served by the DMA controller.

3.26

Serial audio interfaces (SAI1)

The device embeds a dual channel SAI peripheral that supports full duplex audio operation.

The SAI bus interface handles communications between the microcontroller and the serial

audio protocol.

The SAI peripheral supports:



One independent audio sub-block that can be a transmitter or a receiver, with the

respective FIFO



8-word integrated FIFOs



Synchronous or asynchronous mode



Master or slave configuration



Clock generator to target independent audio frequency sampling when audio sub-block

is configured in master mode



Data size configurable: 8-, 10-, 16-, 20-, 24-, 32-bit



Peripheral with large configurability and flexibility allowing to target as example the

following audio protocol: I2S, LSB or MSB-justified, PCM/DSP, TDM, AC’97 and SPDIF

out



Up to 16 slots available with configurable size and with the possibility to select which

ones are active in the audio frame



Number of bits by frame may be configurable



Frame synchronization active level configurable (offset, bit length, level)



First active bit position in the slot is configurable



LSB first or MSB first for data transfer



Mute mode



Stereo/Mono audio frame capability



Communication clock strobing edge configurable (SCK)



Error flags with associated interrupts if enabled respectively

–

Overrun and underrun detection

–

Anticipated frame synchronization signal detection in slave mode

–

Late frame synchronization signal detection in slave mode

–

Codec not ready for the AC’97 mode in reception

STM32WB55 Datasheet(PDF) 55 Page - STMicroelectronics

STM32WB55 Datasheet(HTML) 55 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL