AM85C30-8PC datasheet(31/68 Pages) AMD

31 / 68 page

AMD

Am85C30

Auto RTS Reset

On the CMOS ESCC, if bit D0 of WR15 and bit D2 of

WR7

′ are set to 1 and the channel is in SDLC mode, the

RTS pin may be reset early in the Tx Underrun routine

and the

RTS pin will remain active until the last 0 bit of

the closing flag leaves the TxD pin as shown in Figure

16. Note that in order for this to function properly, bits D3

and D2 of WR10 must be set to 1 and 0, respectively.

CRC Character Reception

NMOS Am8530H

On the NMOS Am8530H, when the end-of-frame flag is

detected, the contents of the Receive Shift Register are

transferred to the Receive Data FIFO regardless of the

number of bits accumulated. Because of the 3-bit delay

between the Receive SYNC Register and Receive Shift

received are never transferred to the Receive Data

FIFO. Thus, the received CRC characters are unavail-

able for use.

CMOS Am85C30

On the Am85C30, the option of being able to receive the

complete CRC characters generated by the transmitter

is provided when both bit D0 of WR15 and bit D5 of WR7

′

are set to 1. When these 2 bits are set and an end-of-

frame flag is detected, the last 2 bits of the CRC will

be clocked into the Receive Shift Register before its

contents are transferred to the Receive Data FIFO. The

data-CRC boundary and CRC character bit formats for

each Residue Code provided are shown in Figures 17A

through 17D for each character length selected.

Data Being Sent

Data

CRC

Flag

Tx Underrun/EOM

RTS Bit D1 WR5

RTS Pin (Active Low)

Figure 16. Auto RTS Reset Mode

10216F-20

AM85C30-8PC Datasheet(PDF) 31 Page - Advanced Micro Devices

AM85C30-8PC Datasheet(HTML) 31 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68

Datasheet Download

Link URL