SW52212 datasheet(59/71 Pages) SILABS

59 / 71 page

10.4 Si52208 Land Pattern

The figure below illustrates the land pattern details for the Si52208 in a 48-Lead, 6 x 6 mm QFN package. The table lists the values for

the dimensions shown in the illustration.

Figure 10.4. 48L 6 x 6 mm QFN Land Pattern

Table 10.4. PCB Land Pattern Dimensions

Dimension

5.90

0.20

3.60

0.85

3.60

0.40 BSC

Notes:

General

1. All dimensions shown are in millimeters (mm) unless otherwise noted.

2. Dimensioning and Tolerancing is per the ANSI Y14.5M-1994 specification.

3. This Land Pattern Design is based on IPC-7351 guidelines.

4. All dimensions shown are at Maximum Material Condition (MMC). Least Material Condition (LMC) is calculated based on a Fabri-

cation Allowance of 0.05 mm.

Solder Mask Design

1. All metal pads are to be non-solder mask defined (NSMD). Clearance between the solder mask and the metal pad is to be 60 mm

minimum, all the way around the pad.

Stencil Design

1. A stainless steel, laser-cut and electro-polished stencil with trapezoidal walls should be used to assure good solder paste release.

2. The stencil thickness should be 0.125 mm (5 mils).

3. The ratio of stencil aperture to land pad size should be 1:1 for the perimeter pads.

4. A 3x3 array of 0.90 mm square openings on 1.15mm pitch should be used for the center ground pad.

Card Assembly

1. A No-Clean, Type-3 solder paste is recommended.

2. The recommended card reflow profile is per the JEDEC/IPC J-STD-020 specification for Small Body Components.

Data Sheet

Packaging

silabs.com | Building a more connected world.

Rev. 1.0 | 59

SW52212 Datasheet(PDF) 59 Page - Silicon Laboratories