DATASHEET

1:10 LVCMOS Zero Delay Clock Buffer

MPC9608

MPC9608 REVISION 4 MARCH 15, 2016

1

©2016 Integrated Device Technology, Inc.

The MPC9608 is a 3.3 V compatible, 1:10 PLL based zero-delay buffer. With

a very wide frequency range and low output skews the MPC9608 is targeted for

high performance and mid-range clock tree designs.

Features

•

1:10 outputs LVCMOS zero-delay buffer

•

Single 3.3 V supply

•

Supports a clock I/O frequency range of 12.5 to 200 MHz

•

Selectable divide-by-two for one output bank

•

Synchronous output enable control (CLK_STOP)

•

Output tristate control (output high impedance)

•

PLL bypass mode for low frequency system test purpose

•

Supports networking, telecommunications and computer applications

•

Supports a variety of microprocessors and controllers

•

Compatible to PowerQuicc I and II

•

Ambient Temperature Range -40

C to +85C

•

32-lead Pb-free Package Available

•

For functional replacement use 2308-2HDCG

The MPC9608 uses an internal PLL and an external feedback path to lock its

low-skew clock output phase to the reference clock phase, providing virtually

zero propagation delay. This enables nested clock designs with near-zero

insertion delay. Designs using the MPC9608 as PLL fanout buffer will show

significantly lower clock skew than clock distributions developed from traditional

fanout buffers. The device offers one reference clock input and two banks of 5

outputs for clock fanout. The input frequency and phase is reproduced by the PLL

and provided at the outputs. A selectable frequency divider sets the bank B

outputs to generate either an identical copy of the bank A clocks or one half of

the bank A clock frequency. Both output banks remain synchronized to the input reference for both bank B configurations.

Outputs are only disabled or enabled when the outputs are already in logic low state (CLK_STOP). For system test and

diagnosis, the MPC9608 outputs can also be set to high-impedance state by connecting OE to logic high level. Additionally, the

device provides a PLL bypass mode for low frequency test purpose. In PLL bypass mode, the minimum frequency and static

phase offset specification do not apply.

CLK_STOP and OE do not affect the PLL feedback output (QFB) and down stream clocks can be disabled without the internal

PLL losing lock.

The MPC9608 is fully 3.3 V compatible and requires no external components for the internal PLL. All inputs accept LVCMOS

signals while the outputs provide LVCMOS compatible levels with the capability to drive terminated 50

 transmission lines on

the incident edge. For series terminated transmission lines, each of the MPC9608 outputs can drive one or two traces giving the

devices an effective fanout of 1:20. The device is packaged in a 7x7 mm2 32-lead LQFP package.

FA SUFFIX

32-LEAD LQFP PACKAGE

CASE 873A-03

AC SUFFIX

32-LEAD LQFP PACKAGE

Pb-FREE PACKAGE

CASE 873A-03

MPC9608

LOW VOLTAGE 3.3 V

LVCMOS 1:10 ZERO-DELAY

CLOCK BUFFER

PRODUCT DISCONTINUATION NOTICE - LAST TIME BUY EXPIRES SEPTEMBER 7, 2016