MPC7448 datasheet(40/60 Pages) FREESCALE

40 / 60 page

MPC7448 RISC Microprocessor Hardware Specifications, Rev. 3

Freescale Semiconductor

System Design Information

Figure 19. Voltage Transient Example

9.2.4

Decoupling Recommendations

Due to the MPC7448 dynamic power management feature, large address and data buses, and high

operating frequencies, the MPC7448 can generate transient power surges and high frequency noise in its

power supply, especially while driving large capacitive loads. This noise must be prevented from reaching

other components in the MPC7448 system, and the MPC7448 itself requires a clean, tightly regulated

source of power. Therefore, it is recommended that the system designer use sufficient decoupling

capacitors, typically one capacitor for every VDD pin, and a similar amount for the OVDD pins, placed as

close as possible to the power pins of the MPC7448. It is also recommended that these decoupling

capacitors receive their power from separate VDD, OVDD, and GND power planes in the PCB, using short

traces to minimize inductance.

These capacitors should have a value of 0.01 or 0.1 µF. Only ceramic surface mount technology (SMT)

capacitors should be used to minimize lead inductance. Orientations where connections are made along

the length of the part, such as 0204, are preferable but not mandatory. Consistent with the

recommendations of Dr. Howard Johnson in High Speed Digital Design: A Handbook of Black Magic

(Prentice Hall, 1993) and contrary to previous recommendations for decoupling Freescale

microprocessors, multiple small capacitors of equal value are recommended over using multiple values of

capacitance.

In addition, it is recommended that there be several bulk storage capacitors distributed around the PCB,

feeding the VDD and OVDD planes, to enable quick recharging of the smaller chip capacitors. These bulk

capacitors should have a low equivalent series resistance (ESR) rating to ensure the quick response time

necessary. They should also be connected to the power and ground planes through two vias to minimize

inductance. Suggested bulk capacitors are 100–330 µF (AVX TPS tantalum or Sanyo OSCON).

9.3

Connection Recommendations

To ensure reliable operation, it is highly recommended to connect unused inputs to an appropriate signal

level. Unless otherwise noted, unused active low inputs should be tied to OVDD and unused active high

inputs should be connected to GND. All NC (no connect) signals must remain unconnected.

VDD (nominal)

1.40 V

A + B < T • 10%

1.35 V

VDD (maximum)

C < T • 0.2%

VDD (minimum)

Normal

Low Transient

High Transient

MPC7448 Datasheet(PDF) 40 Page - Freescale Semiconductor, Inc

MPC7448 Datasheet(HTML) 40 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Datasheet Download

Link URL